Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Wheels & Tyres

Tyre changing & air suspension
Post Reply  Down to end
Page 1 of 1
d3syd
 


Member Since: 04 May 2006
Location: Scamander, Tasmania, Australia
Posts: 168

Australia 2006 Discovery 3 TDV6 SE Auto Buckingham BlueDiscovery 3
Tyre changing & air suspension

Has anyone encountered problems getting the wheel on and off the hub with air suspended vehicles?

Instructions says to put car in extended mode to change tyre. I found that I had to jack the car up a long way to get the wheel off the ground as the suspension kept dropping. Eventually got it off, but when I went to put the repaired wheel back on the hub had dropped further than I could jack the car up, hence I couldn't get the wheel back on Evil or Very Mad

I tried starting the car and lowering the suspension, hoping that this would raise the hub. This worked momentarily, then the car went into extra extended mode (as it thought that it had bottomed out due to being jacked up) and dropped the hub even further. Rolling Eyes

Luckily I had a second jack handy to put under the wishbone and jack up the hub to get the wheel on.

Two thoughts came to mind: 1. What if I didn't have another jack, and 2. Censored smart ass car.

Any suggestions?
 '06 TDV6 SE AUTO BUCKINGHAM BLUE
'98 Volvo V70
'87 Mecedes 420 SEL
'08 BMW 135i Coupe Twin Turbo 
 
Post #16733915th Jun 2007 11:13 am
View user's profile Send private message View poster's gallery Reply with quote
ronp
 


Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263

Scotland 2014 Discovery 4 3.0 SDV6 HSE Auto Corris GreyDiscovery 4

Seems very strange!!
I had a puncture a few week ago and changed it myself.
Did everything by the book and experienced no problems.
Don't think you mentioned if it were front or rear - mine was front.
Think maybe a discussion with the dealer would be in order.
 ...... always on the road less travelled 🚧  
Post #16734215th Jun 2007 11:25 am
View user's profile Send private message View poster's gallery Reply with quote
NoDo$h
 


Member Since: 02 May 2006
Location: Finding new and exciting ways to milk badgers.
Posts: 19689

Ukraine 

The handbook is total Censored on this subject. Far easier to do with the car locked into access height, although somewhat harder to get the jack in place. One of the reasons I've bought an air jack Thumbs Up

I guess removing the keys from the ignition wouldn't have helped? Whistle
 I know it's not considered "kind" to say no these days, but no. Just no, ok? And if it's not ok, still no.  
Post #16734315th Jun 2007 11:26 am
View user's profile Send private message View poster's gallery Reply with quote
simon
  


Member Since: 11 Jan 2005
Location: Shropshire
Posts: 18296

United Kingdom 2011 Discovery 4 3.0 SDV6 HSE Auto Fuji WhiteDiscovery 4

Leave a door open... it stops the suspension doing anything. Rear hatch excluded as it will still drop with it open.

And off road height is what you need to set (probably so you can get the spare off).
  
Post #16734815th Jun 2007 11:47 am
View user's profile Send private message View poster's gallery Reply with quote
d3syd
 


Member Since: 04 May 2006
Location: Scamander, Tasmania, Australia
Posts: 168

Australia 2006 Discovery 3 TDV6 SE Auto Buckingham BlueDiscovery 3

Sorry ronp, it was the back wheel. Yes I had to change a front wheel a year ago and had no problems. NoDo$h, I thought of locking the car in access height only after I got the wheel back on. Will try that next time!
 '06 TDV6 SE AUTO BUCKINGHAM BLUE
'98 Volvo V70
'87 Mecedes 420 SEL
'08 BMW 135i Coupe Twin Turbo 
 
Post #16735415th Jun 2007 12:36 pm
View user's profile Send private message View poster's gallery Reply with quote
ferrett
 


Member Since: 15 Jan 2006
Location: West
Posts: 298

United Kingdom 2012 Discovery 4 3.0 SDV6 XS Auto Firenze RedDiscovery 4

Had a flat a few weeks ago (nearside rear), changed it as per the instructions in the manual and all was fine, I used a 3 ton trolley jack posiioned under the jacking point detailed in the manual.

In fact as I was jacking the vehicle the suspension lifted that corner just as the wheel cleared the ground, scared the Censored out of me.
 2012 D4 - SDV6 XS - Firenze Red  
Post #16740515th Jun 2007 7:00 pm
View user's profile Send private message View poster's gallery Reply with quote
drivesafe
 


Member Since: 23 Feb 2006
Location: Gold Coast, Australia
Posts: 867

Australia 

Hi d3syd, as simon posted, leave a door open.

I sure this suspension lockout while a door is open was probably designed to stop a door being damaged if it’s opened over an object and the vehicles is lowered but it also works as a safety device while trying to change wheels and foe the same safety reasons, this info should be made very clear in the owners manual.

Cheers
 2008 TDV8 RR Lux + 2009 D4 2.7  
Post #16740815th Jun 2007 8:46 pm
View user's profile Send private message View poster's gallery Reply with quote
jh972
 


Member Since: 19 Feb 2007
Location: Sydney
Posts: 37

Australia 2007 Discovery 3 TDV6 SE Auto Stornoway GreyDiscovery 3

Also, somewhere in the book (or latrest book) it says to take the key out.
That possibly does the same as leaving the door open.
  
Post #16741515th Jun 2007 11:55 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
drivesafe
 


Member Since: 23 Feb 2006
Location: Gold Coast, Australia
Posts: 867

Australia 

Unfortunately removing to key does not stop the suspension from trying to level itself.

I think you will find that the instruction of removal of the key is more to avoid having you or someone else accidentally starting the vehicle while it’s jacked up.

As posted above not even leaving the tailgate open will stop the suspension from working.

To my knowledge only having a door, any door, opened will override the suspension operations.

Cheers.
 2008 TDV8 RR Lux + 2009 D4 2.7  
Post #16743116th Jun 2007 6:32 am
View user's profile Send private message View poster's gallery Reply with quote
d3syd
 


Member Since: 04 May 2006
Location: Scamander, Tasmania, Australia
Posts: 168

Australia 2006 Discovery 3 TDV6 SE Auto Buckingham BlueDiscovery 3

I think the best suggestion is from NoDo$h - lock it in access height. That way you don't have to jack the car up as high with that Censored unstable sissor jack. There should be enough clearence to get the spare off I'm sure.

Oh by the way, I forgot to mention in my original post. The wheel brace is equally Censored , I broke it tightening up the nuts!! It's made of mild steel - ridiculous Evil or Very Mad Evil or Very Mad
 '06 TDV6 SE AUTO BUCKINGHAM BLUE
'98 Volvo V70
'87 Mecedes 420 SEL
'08 BMW 135i Coupe Twin Turbo 
 
Post #16743416th Jun 2007 7:24 am
View user's profile Send private message View poster's gallery Reply with quote
NoDo$h
 


Member Since: 02 May 2006
Location: Finding new and exciting ways to milk badgers.
Posts: 19689

Ukraine 

You can lower the spare and get that out before dropping the car to access height. I don't use the supplied brace; I've got a breaker bar with the right size socket welded to it as the original is made of recycled tin Shocked
 I know it's not considered "kind" to say no these days, but no. Just no, ok? And if it's not ok, still no.  
Post #16752916th Jun 2007 9:25 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site