Member Since: 28 Jan 2023
Location: stockholm
Posts: 8
traction control
I was stuck in the snow traction control system did work properly in a Land Rover Discovery 4, 3 wheels spinning and slipping one wheel not spinning normally brake should be applied on the spinning wheel so the power goes to the wheel which is not spinning ( two front wheel and right rear wheel spinning). if anybody can explain why thanks
28th Jan 2023 8:56 pm
Motolab
Member Since: 18 Oct 2019
Location: Sleen
Posts: 1815
Hi! Hello!
Welcome!
Just a small tipp, there is a lot of help here if needed
If you do a “say hello topic entry first” it sure does help i have seen..
In some driving conditions, it may be appropriate to switch DSC off to improve traction. These conditions include:
Rocking the vehicle out of a hollow or deep rut.
Pulling away in deep snow, or from a loose surface.
Driving through deep sand or mud.
DSC should be switched on again as soon as the difficulty is overcome.
29th Jan 2023 11:39 am
ericsddfdd
Member Since: 28 Jan 2023
Location: stockholm
Posts: 8
gstuart wrote:
Plus 1 and a warm welcome
Hope this video also helps , plus in slippery conditions keeping the revs up and turning the DSC off can sometimes assist
DSC stands for Dynamic Stability Control
Thanks, I have tried with DSC off didn't work maybe not long enough.
in the video, slipping is detected immediately, but in my case, it was not like that
-is that possible that the brake line is connected to the wrong wheel
in this case, can the car find that there is a problem?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
