Member Since: 21 Jan 2007
Location: Yorkshire
Posts: 2049
Trolly jack question
Put the ST on tonight using trollyjack with the new adaptor that works well only thing is when in off road height the jack is struggeling at the extreme height ,so I was wondering if I could get some bigger wheels on the front end ,thoughts please.
It's possible, the wheels on mine are 90mm dia, 20dia shaft and 45mm wide, the 150mm dia could be fitted, although personaly I would want the rear castor wheels increased in height to match, this would be more difficult.
Member Since: 23 Jun 2006
Location: W.London.
Posts: 2345
How about putting some thick plywood on the ground and then put the trolley jack on that, much easier, and stops you damaging your drive too. PS, it's important to make sure the trolley jack can roll freely on its wheels as you jack the vehicle though.
3rd Dec 2008 10:25 pm
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15264
Exactly what I do DND3
And need to do it again today, cos I'm on the wrong tyres!!!!
Got a dumping of snow so need to get these MTR's back on....... always on the road less travelled 🚧
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
PS, it's important to make sure the trolley jack can roll freely on its wheels as you jack the vehicle though.
