Member Since: 07 Feb 2021
Location: Warwickshire
Posts: 99
[Wanted] O/s rear wheel arch trim
Above trim in Stornaway Grey. Just removed to investigate why it was sticking out and found 3 of the 4 brackets broken.
6th Mar 2021 12:20 pm
darrind
Member Since: 04 Jul 2008
Location: In A World of My Own!
Posts: 2892
If the trim labs are still there on the car it is possible to weld them together by melting additional plastic - you can also reinforce with some small metal staples or paper clips heated to melt into the plastic. Will make it stronger than the original part if done right.
If you take a look at the back there is normally a description of the plastic type on there - ABS or PP or something, ideally use the same plastic to melt into the weld
Take a look on YouTube theres plenty of videos how... Must stop buying shiny toys....
6th Mar 2021 1:21 pm
Jong0211
Member Since: 07 Feb 2021
Location: Warwickshire
Posts: 99
Think two of them were broke off before my ownership. Only removed as one end was sticking out. Now can’t put it back on pmsl
6th Mar 2021 5:28 pm
Jong0211
Member Since: 07 Feb 2021
Location: Warwickshire
Posts: 99
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
