Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Wheels & Tyres

Wheel studs
Post Reply  Down to end
Page 1 of 1
Nuts 2
 


Member Since: 02 Apr 2019
Location: Stroud
Posts: 10

United Kingdom 
Wheel studs

Hi all new to hear and I’ve just bought a d4 commercial I loved the look of the vehicle but didint like the alloys so I bought some after market alloys I had a look at all the landrover ones on that auction site but just couldn’t find what I wanted hence the after market ones I spoke to the seller and he confirmed they would fit my disco 4.
When they arrived I was straight down the tyre fitters to have four new Goodyear duratracs fitted and the wheels put on the disco first problem they incountered was that the new wheels were wider than the old ones and would require spacers secondly the short studs on the hubs were not long enough as the centres on the new alloys are thicker so if I went shopping determined to get the wheels fitted.
A week later I had what I needed the wheels are now fitted and look great the only problem is the edge of the tyre is slightly wider than the wheel arch the narrowest spacer I could get with studs in was 30mm
I have seen some 15mm ones that will fit but you need bolts not studs.
So my question is are the d4 studs hammered in on splines or are they threaded if they are threaded does anyone no what size and pitch the thread is ? So I can get some long wheel bolts to replace the studs and fit 15mm spacers.
  
Post #20435765th Apr 2019 9:02 pm
View user's profile Send private message View poster's gallery Reply with quote
lynalldiscovery
 


Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274

United Kingdom 2006 Discovery 3 TDV6 Metropolis LE Auto Bonatti GreyDiscovery 3

I could be wrong bere but think the last time land rover used threaded studs that screwed into the hub was in the early 60s.
  
Post #20436095th Apr 2019 10:36 pm
View user's profile Send private message View poster's gallery Reply with quote
M3DPO
 


Member Since: 22 Sep 2010
Location: Notts.
Posts: 8041

England 2014 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

What size are the wheels and tyres?- 18” will not fit a D4.
Do they have the correct load capacity for a Discovery?- if not your insurance could be invalidated if they are not notified and agree on the none standard wheels being fitted.
Discovery’s eat wheel bearings without spacers, with them......not recommended Whistle
 It can when others can't,
It will when others won't,
It goes where others don't. 
 
Post #20436226th Apr 2019 5:56 am
View user's profile Send private message View poster's gallery Reply with quote
Disco_Mikey
 


Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20713

Scotland 2005 Discovery 3 TDV6 HSE Auto Cairns BlueDiscovery 3

I never had a bearing failure in 80k miles while running spacers Thumbs Up
 My D3 Build Thread

TDV8 Retrofit Build Thread 
 
Post #20436236th Apr 2019 6:20 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Nuts 2
 


Member Since: 02 Apr 2019
Location: Stroud
Posts: 10

United Kingdom 

There 19” rims with 255-55 duratracs fitted the rims are 8.5j the I had the discussion with the seller before I bought them and he assured me they were suitable for a d4.
By the sounds of it they are nock in studs not threaded?
  
Post #20436326th Apr 2019 7:42 am
View user's profile Send private message View poster's gallery Reply with quote
M3DPO
 


Member Since: 22 Sep 2010
Location: Notts.
Posts: 8041

England 2014 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

You may have to strip and examine them as it is highly likely they are not originals particularly on the front and different manufacturers may use different methods, they are more likely to be splined knock in type, the hubs come as a unit that cannot be split and you may have problems fitting longer studs in particularly on the rear.
I can understand your problem with them being wider, I run 275 in summer and the car really gets messed up on the sides from spray from the wheels.







 It can when others can't,
It will when others won't,
It goes where others don't. 
 
Post #20436576th Apr 2019 10:20 am
View user's profile Send private message View poster's gallery Reply with quote
NJSS
 


Member Since: 06 May 2009
Location: Catherington, Hampshire.
Posts: 10463

United Kingdom 2016 Discovery 4 3.0 SDV6 Landmark LE Auto Waitomo GreyDiscovery 4

Nuts 2

Welcome. Don't forget to advise your insurers of the spacers, wheels & tyres you have fitted.

NJSS
 Am I Gammon or Woke ? - I neither know nor care.

2016 Discovery 4 Landmark
2011 Mercedes Benz SL350 (R230)
1973 MG B GT V8 - 3.9L John Eales engine, 5 speed R380 gearbox, since 1975.
1959 MGA roadster - 1.9L Peter Burgess Engine - 5 speed gearbox
Past LRs - Multiple FFRs, Discos & a Series I - some petrol, some diesel,
none Electric or H2 fuel cell - yet.
There are 10 types of people in this world: Those who understand binary, and those who don’t. 
 
Post #20436586th Apr 2019 10:32 am
View user's profile Send private message View poster's gallery Reply with quote
Nuts 2
 


Member Since: 02 Apr 2019
Location: Stroud
Posts: 10

United Kingdom 

Thanks for all the info guys it looks like it’s going to be serious hassle to change the stud lengths looks like I’m going to have to stick with the 30mm spacers the tread of the tyre doesn’t stick out past the arch just the side wall when you look straight down hopefully this passes the mot when it’s due next year?
  
Post #20438437th Apr 2019 7:30 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site