| Search results - "NEXT" |
Next to Tel Aviv beach73 views
|
|
Snowmobil next118 views
|
|
01 Start of Xmas 07 trip across the Australian Nullabor243 viewsThis is the preferred method of travelling 2500km of Nullabor desert when time is short (the Indian Pacific train). Next stop is Adelaide.
|
|
11 Lesson in removing a jammed brake assembly in the Outback379 viewsSpent the next 4 hours doing this to my D3. Gave the photos to Land Rover dealer and they did not think this constituted abuse of the vehicle. I thought that was charitable, but if we hadn\'t done this, the tow back to civilisation would have been even longer.
|
|
Quite a contrast!462 viewsMy outgoing Polo looked like a toy next to my new Disco.
|
|
nice and warm next winter65 views
|
|
Green Lanning in Cumbria 2012 Calendar326 viewsTaken next to "The Watercut" on The Old Highway above Mallerstang in Cumbria
|
|
Wondering what to do next.....coffee!!199 views
|
|
tin bong next to pc21 views
|
|
Lunar Ultima parked next to Disco 411 views2015 Lunar Ultima & Disco 4
|
|
As it was when I had hd enough at night, next day to wire in HF antennae293 views
|
|
4 pin NAS flat connector from NAS small trailer382 viewsThe connector with the three exposed pins is the end that would commonly be located at the trailer hitch end, (front), of a small NAS lightweight trailer that has no electric brakes. This plug would connect into the flat 4 pin connector at the rear of the 3.
Note the order of the pin functions and wire colours: White is ground; the next pin is for tail/marker lights using the Brown wire; the Yellow conductor is for the left turn signal, and the far pin uses the Green conductor for the right turn signal.
There is no separate brake light conductor as NAS spec vehicles most often combine the brake and signal light functions to the same bulb filament rather separate filaments in different bulbs. The LR factory harness resolves that design difference.
Fortunately, the Land Rover NAS assembly pin order for the 4 pin flat plug maintains the above described conventions.
|
|
Next seasons haircut, apparently.156 views
|
|
-21 deg and doing my bit for global warming.......... dont think the tree hugging Toyota next to me was too impressed193 views
|
|
112 viewsThe next best thing to a D3
|
|
Funny who you meet in the car park....227 viewsParked in a stupid place this lunchtime...
...and guess who parked next to me?
|
|
Comparison with X5123 viewsAfter the training - couldn´t resist parking next to the x5...
|
|
Thread upload13 viewsImage uploaded in thread 147165
|
|
Thread upload2 viewsImage uploaded in thread 159579
|
|
next D5 muon engine161 views
|
|
My next D3273 views
|
|
190 viewssignal wire pin 3 on rear of D4 rear light plug fit 6 ohm 50 watt resistor across here and common ground Pin 5 yellow terminal shown in next pic
|
|
My new set of 4 wheels next to my old set of 10...213 views
|
|
ac plugs on RHS next to fridge190 views
|
|
Remains of a troop carrier next to the road. On the way to Ondjiva. Worst road in the world!163 views
|
|
Big Dave Next45 views
|
|
antennae next to Disco3 Keyfob96 views
|
|
Disco3 at Carantouhill CALENDAR ENTRY 2009441 viewsCarantouhill, Irelands highest peak. a group of us set off in my disco 3 and friends defender 90. it was a nice trek to the base, with a small river crossing and some big rocks to navigate around. we camped out and climbed the mountain the next day. summer of 2008.
|
|
When is the next bus104 views
|
|
252 viewsWe did it!! Winner of the first Northam Mud Drags. Now to get ready for next month\'s comp ...
|
|
149 viewsThis is a JPEG Taken from the CAD drawing, it has nothing to do with NEXT BASE OR LAND ROVER,FORD TATA, its just a FUN Model and not to be used.......
|
|
EGR Valve/Pipe Flange896 viewsThe bolts in the inset are the ones to be removed. Note the rag stuffed down beside the EGR to prevent dropped bolts or gaskets disappearing for ever. Don\'t forget to take the rag out if you don\'t want your D3 to go up in flames next time you use it!
|
|
218 views
|
|
181 views
|
|
Pass seat wiring108 viewsClose up showing the re worked Pass seat wiring on the D3 loom next to the sport one.
|
|
Gareth\'s new G4 next to my SE82 views
|
|
Next base with new Bracket62 views
|
|
147 viewsbuilt painted and ready for monitor (NEXT BASE)
|
|
My next D3 hanging out at GS (old one behind)97 views
|
|
68 viewsA short trip to the French/ Italian Alps.
The boy isn't quite big enough to ski just yet.. maybe next year..
|
|
533 viewsAdded an extra switch to the + leading to my PC and to the MP3 changer. As such I can cut off the power to both systems when needed. Learned that one after 2 days constantly working in the car, lighting the whole thing up during 2 days and noticed I couldn't start anymore :D. Saved by my wife's Freelander next to me :)
Also to be seen is the remote controller of the MP3-changer.
|
|
16 viewsCars going out for filming for next series
|
|
Trial Fit of Grill Mod154 viewsD3 grill cut out and FFRR grill inserted for final cutting of profiles. Next stage to prime and paint grill in finished colour and then bond FFRR section in place.
|
|
tough Himba warrior next to an even tougher vehicle170 viewsPicture taken by Paulo Fernandes
|
|
21 viewssome friends had uploaded temp pix of -21 and -27
so i wanted you all to feel the heat we have here in Kuwait...
it was 52C :( yes, i mean 52C not 25C
my next test will be to fry an egg on the bonnet :)
|
|
Next I will install additional high beam lights318 views
|
|
7" tft lcd display to replace rear mirror385 views one of my next projects
|
|
Thread upload1 viewsImage uploaded in new thread
|
|
Thread upload1 viewsImage uploaded in new thread
|
|
Thread upload2 viewsImage uploaded in new thread
|
|
Thread upload1 viewsImage uploaded in new thread
|
|
Thread upload2 viewsImage uploaded in new thread
|
|
LR3 Denso Alternator YLE500390 rear view709 viewsThis picture shows the rear of the YLE500390, the Land Rover part number for a newer design alternator utilizing the Transpo IN6349 regulator with the "hidden" cooling fins. Note the visual difference in the rear view of the next file jpg.
If the alternator is a rebuilt, (service exchange unit), but Land Rover supplied, then the part number is LR008860 or similar. (Note that 0 in LR0 is zero.)
Two Denso part numbers exist for the alternator as well, 4280003690 and 4280003691. The rating of the petrol V8 alternator is nominal 12 VDC and 150 amps. In normal day to day operation, they seem to run about 14VDC - usually between 13.9 and 14.1 volts at the OBD port.
For the petrol V6, the LR service exchange number is LR008862, and the 2.7TDV6 is LR008861.
The bridge rectifier within the alternator is a 12 diode avalanche type, 117mm diameter, as used in Nippondenso 120 to 160 amp alternators with the Hair Pin stator. It is similar to a Transpo INR421 which is rated for 120 to 150 amp alternators. That is probably our primary problem - the rectifier is just too light. Alternate part numbers for the bridge rectifier are Cargo 237607, Mobiltron RM-29 and AS ARC6021.
Re the B+ stud, the INR421 calls it up as an M8 x 1.25 x 30 mm long course threaded stud; some say 34 mm but that may be longer than desirable.
|
|
Rose Garden Hill111 viewsOn the way back from checking out Rose Garden Hill. We did not do the actual hill (maybe next time).
|
|
Thread upload6 viewsImage uploaded in thread 146825
|
|
Thread upload24 viewsImage uploaded in thread 70979
|
|
Thread upload5 viewsImage uploaded in thread 159579
|
|
Coming out of an small off-camber ravine472 viewscoming out of an off camber ravine and lining up for the next gate. The LR3's traction control was great, even with the stock tires there was virtually no slipping.
|
|
Battery Box Primary186 viewsThis visual is what is next to, behind and under your battery. It is important to note that the negative terminal which is prone to corrosion is in the rear, nearest to everything to maximize damage. The white powder pictured is baking soda. This is carefully used with a damp rag to neutralize any effect of battery acid (hydrochloric acid).
|
|
Minyon Falls - Nightcap NP111 viewsWest of Byron Bay (approx 28º27'S, 153º23'E) in the Nightcap National Park. Rocky Creek Dam is in the next valley west and supplies water to much of NE NSW.
|
|
TFC179 viewsNext to my joy (the pride is the D3) ;-)
|
|
Calendar Entry843 viewscalendar entry: January 2008, Perron Dunes near St Helens, NE Tasmania, Australia. Next attempt, turned the DSC off :-)
|
|
next to river tweed at norham69 views
|
|
next to river tweed at norham80 views
|
|
next to river tweed at norham98 views
|
|
Anyone can have puncture!638 viewsMust remember to take a proper jack next time.
|
|
127 viewsThats Me (mine) on the left at McDonalds Kempsy New South Wales. (Next to two older siblings)
|
|
1:10 Scale D3 next to RC chassis63 views
|
|
93 viewsThe river next to the field of blue flowers. We ended up crossing this river dozens of times and eventually drove in it it for more than a mile.
|
|
Meet you at the next bend137 views
|
|
Pattern for Expo Roof Rack Floor Sheet397 viewsI used a 3mm sheet of Aluminium - with 150mm wide Grip Tape to do the Chevron Patter to make it a bit safer. Note the sheet is 1610mm long, 1100mm wide at the front and 1060mm wide at the back. I drilled 3 rows of 5x 12mm holes - one row down the centre and one either side 30mm in from the edge. The hole centres being at 31mm from the front edge, next 420mm from 1st hole centre, the 375mm from 2nd hole, 372mm from 3rd hole, 375mm from 4th hole, leave 31mm to the back edge. Edited May 2008: I've subsequently cut the sheet in half lengthways to make removal and fitting easier as I found the sheet increasing noise and reduces MPG considerably.
|
|
RRS tyre next to Disco tyre84 views275/40R20 tyre from a RRS next to a 295/45R20 Disco3 tyre
|
|
NAS 7 pin + NAS 4 pin Flat Trailer Socket308 viewsThis is the vehicle end of the NAS trailer harness that is located behind the removable plate centered within the rear bumper by the towing loop. Re the four pin flat connector, from the bottom, the exposed bare lower pin is the ground, usually the White wire on a NAS trailer. The next pin up is normally a Brown wire on a trailer and is for the Tail Lights. The third pin, normally a Yellow wire, is the left signal light; the top pin, normally a Green coloured wire, is the right signal light.
Re the round connector, from the notch in the plastic surround, clockwise, the first blade is ignition controlled +12VDC battery power, (only alive when engine running), and on the Land Rover factory harness is an Orange wire; on a NAS trailer, usually Red but perhaps a Black wire.
Next blade clockwise at 3:00 o'clock above, is the Right Turn signal light, a Green wire on the LR harness, and also on a NAS trailer.
At 5:00 o'clock, the next blade is for the Electric Brakes and is Blue on both the LR harness and on a NAS trailer.
The Ground wire is next, White on both the LR harness and on a trailer.
At 9:00 o'clock above, is the Left Turn signal, Yellow on both the LR harness and on a trailer.
The last blade to the left of the line up notch is the Tail Light circuit. On the LR harness, the wire colour is Brown with two White stripes and on a NAS trailer, Brown.
The centre pin is for the Reverse Back Up lights and is Black on the LR harness and often Purple on NAS trailer wiring but can be Black also.
Note that when the socket assembly is installed on the 3, the notch in the plastic surround is on the left - that is rotated 90 degrees anticlockwise to the picture above. In other words, When installed on the 3, the 4 pin flat connector lays horizontal and is located below the round socket.
|
|
Three Discos (including Next Door Neighbours)126 views
|
|
Next morning11 views
|
|
Small World282 viewsWent to Paris last weekend, turned out of hotel and this was next door!
|
|
DiscoWex goes in for the kill, success favours the brave96 views
|
|
What happened next?81 views
|
|
WillMyth goes for the unsuspecting grazing defenders below105 views
|
|
CALENDAR ENTRY468 viewsDisco 3 Next to his older brother!
|
|
Main loom passes through bulkhead behind the engine bay fuse box next to the battery140 views
|
|
|
|
|
|
|
