Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D3)

HDC and Park Brake fault
Post Reply  Down to end
Page 1 of 1
porterrich
 


Member Since: 28 Apr 2015
Location: Dubai
Posts: 1

United Arab Emirates 2008 LR3 4.4 V8 HSE Auto Atacama SandLR3
HDC and Park Brake fault

Hi All
I could do with some assistance trouble shooting some faults, I have the HDC failure and Park Brake Fault up. My diagnostic reader tells me there is a speed sensor fault (from what i've read this could well be the issue). I have changed the sensor out and performed a reset from the diagnostic reader and a hard reset but the fault is still there. I have disconnected the other side speed sensor and the fault came in and cleared once I re-connected it. I have unplugged the large plug of the ABS control module in the secondary battery compartment it all looks clean as a whistle inside.

Do these go bad often?

I was about to try and measure the loop for that circuit, it is the rear right sensor according to the diagnostic does anyone have a pin layout for the main plug so I can verify against the good sensors. If anyone has any other ideas to i'm open to suggestions.

regards
Richard
  
Post #16782197th Jul 2016 11:49 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site