discophil36
Member Since: 17 Jul 2014
Location: Renfrewshire
Posts: 142
|
Can I swap relays to check for faulty one??? Relay 7 |
|
Hi I'm looking at my friend's d3. Question is can I swap the number 7 relay to check for a fault there as his compressor is trying to run all time until it cuts out due to hear obviously .
If you want the full fault historym it was found on its knees after sitting a few days . And he couldn't get it to raise. hes had compressor issues with cutting in all time and off when overheating . Leading to slow rising warnings and ultimately an amber suspension fault .
Faults via my iidtool relate to temperature of compressor motor. And also lost Comms with EPB module but he has disconnected this and doesn't use it 🙄. I've got live values of 130°c for motor and compressor temp when running
Anyway got car back to normal height and cleared codes but still compressor cuts in and if I ask it to go to off road height I get the rising slowly fault and los
|
10th Jul 2022 5:04 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10368
|
well yeah, but there are only so many 70A relays in there
The start motor is another I think. Should you want to distirb that
|
10th Jul 2022 5:10 pm |
|
|