Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Camping, Caravanning and Holidays

Elddis (Explorer group) bought by Hymer
Post Reply  Down to end
Page 2 of 2 <12
PadraigH
 


Member Since: 06 Jul 2017
Location: Dublin
Posts: 1

Ireland 

Gareth wrote:
Hopefully sort out the recent shocking build quality. My Affinity 550 is a lovely design, but I've given up on Elddis sorting out the bugs. They don't give a stuff!

So far, I've put decent screws into the interior to stop it falling apart, sealed up the Heki roof light to stop a leak- Glossop caravans had 2 goes and failed. I've fixed a stress crack in the rear panel, that Elddis said was not a water ingress risk and was therefore not covered under the warranty!

Now it's a good caravan, but the hassle I have had means I will not buy another Elddis, or go anywhere near Glossop caravans!!


Hi Gareth, I have just come across stress crack in the rear panel on the right hand side. It is leaking water into the van. How did you go about repairing the stress crack in the rear panel? Are you able to upload a brief outline and the materials you used? I'm thinking about removing the rear panel over the winter and using Resin with a small amount of Catalyst and heavy fiberglass mat - sand outside stress crack and re-gel with the same colour.
  
Post #18343386th Jul 2017 8:33 pm
View user's profile Send private message View poster's gallery Reply with quote
Gareth
Site Moderator 


Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26779

United Kingdom 

Nothing that elaborate needed. The crack on mine was at the top rear corner, radiating out from a screw fastener holding the awning rail on. It was about 4 cms long.

To repair :

1. Drill a 2mm stop hole at the very end of the crack. This relieves the stress in the crack, and stops further spread.

2. Use a dremel or similar and turn the crack into a V shaped groove all along its length.

3. Use proprietary ABS glue or repair paste to fill the V. Fill it slightly proud to allow sanding smooth. You can make your own paste by dissolving some white Lego bricks in acetone.

4. Sand smooth. Use a bit of automotive body filler to finish off.

5. Mask surrounding area and spray white. I used Halfords gloss white spray which matches very well.

So far the crack has not reappeared. The important thing is the stop hole.
  
Post #18343736th Jul 2017 9:42 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 2 of 2 <12
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site