Member Since: 09 Oct 2012
Location: Oxford
Posts: 10
Common Rail Connection
Hi all, I need to find the CR sensor (3pin)connector to the common rail on my D4 2011 HSE any help would be appreciated.
27th Dec 2013 4:10 pm
nigel207
Member Since: 26 Mar 2009
Location: Nottinghamshire
Posts: 1359
If that's for connecting your Speedhawk unit, if the D4 is like the D3, then there's only one electical plug, and it's right on the end of the fuel rail.
28th Dec 2013 9:41 am
marcosail
Member Since: 02 Apr 2011
Location: Napoli
Posts: 70
Is it possible to connect it without dismount everything?
18th Jan 2014 9:13 am
hector97
Member Since: 09 Oct 2012
Location: Oxford
Posts: 10
Sorry I have given up trying to fit the box and sent it back, even the suppler could not help,did not get anywhere with LR dealer ether.
18th Jan 2014 4:58 pm
Robbie
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
Probably for the best really. I never trust the things, only a remap will do.Land Rover - Turning Drivers into Mechanics Since 1948
Member Since: 02 Jul 2006
Location: Oberon, NSW
Posts: 6922
As above. “There are only three sports: bullfighting, motor racing, and mountaineering; all the rest are merely gamesâ€
Ernest Hemmingway
D4 3.0 Active Diff, Adaptive Lights, High Beam Assist, Surround Cameras, Privacy Glass.
D3 2.7:Adaptive Headlights,Electronic Rear Diff,ARB Bar,Blaupunkt Speakers,JVC Powered Subwoofer,Removable Snorkel,Mitch Hitch,Pioneer After Market Head Unit,Steering Wheel Control Adaptor,Remote Adjustable Supension Rod System, Taxside Dual Battery System.
18th Jan 2014 9:55 pm
allforus
Member Since: 20 Mar 2010
Location: Cumbria
Posts: 492
Need to remove the engine cover and the sound proofing from the drivers side of the injectors and the fuel bar is right there The sensor is hard to get at the how to is to use a cable tie and form it around the plug body pull it tight this presses the holding clip on the plug and allows you to slide the plug off before fitting the plug from the tunning box again put a cable tie over the plug but leave loose for use later for removing the box prior to service etc
It is quite difficult to re fit the plug you may have to trim back the outer protection plastic from the three cores allowing you to bend the cable at right angles then it's like golden shot
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
