Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Webasto Fuel Burning Heater

How to build yourself a FBH controller
Post Reply  Down to end
Page 9 of 23 <123 ... 8910 ... 212223>
discostick
 


Member Since: 08 Nov 2012
Location: Kent
Posts: 317

United Kingdom 2005 Discovery 3 TDV6 S Manual Bonatti GreyDiscovery 3

Nodge68 wrote:

This would make a brilliant diy assembly project kit, especially if the PIC was pre - programmed Wink


Thumbs Up
  
Post #136277822nd Oct 2014 9:40 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
discostick
 


Member Since: 08 Nov 2012
Location: Kent
Posts: 317

United Kingdom 2005 Discovery 3 TDV6 S Manual Bonatti GreyDiscovery 3

epninety wrote:
Just for info, here's my webasto controller made last year, or at least the bare pcb from it. Mine was made to interface to the telestart remote, but it can also operate from a pushbutton (to do the same as a 1533), and could probably be made to trigger from the lights in the same way as Alex unit does.

Click image to enlarge



5cm x 2cm

I can't remember the exact parts cost, but it was under £15 and I didn't make any particular effort to keep the cost down - it even uses a 32bit micro. I just used parts I had to hand or was familiar with.

Dave


Nice work Dave.
  
Post #136278222nd Oct 2014 9:44 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
epninety
 


Member Since: 12 Oct 2012
Location: Hampshire
Posts: 329

Wales 2005 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

Yep, exactly as you suggest. It reads the commands from the telestart, and changes the address to represent the 1533 timer, or the thermo test software. It has its own timer though, and uses a small switch on the back of the board to select the heating time.

The code should be easy to port over if you code C, I used an ST Micro ARM device because I was using them for a work job. I can't write C, the code is embarassingly bad (I'm an RF engineer), but if you promise not to laugh I'll try to dig it out.

One other forum member has the same unit installed - I hope it's still working for him, he hasn't said otherwise.

I've got blank PCBs and probably sets of parts, but no spare time to assemble any more units, or properly document the design, up-issue the pcb etc..

I just dug in the bench to find an assembled board to photograph, and found my homebrew thermotop test interface. It reminded me that the other thing I put in my timer board was a mode to read out the fault code, and clear stored faults - handy if you've been running low on fuel.

http://www.disco3.co.uk/gallery/albums/use...22_001.jpg
  
Post #136278522nd Oct 2014 9:45 pm
View user's profile Send private message View poster's gallery Reply with quote
tobouk
 


Member Since: 01 Jun 2014
Location: Knutsford Cheshire
Posts: 35

England 

Well you’ve got further than me, done projects in assembly but struggle with the comms side. Took early retirement this year, electronics eng at local airport for last 30 years, trying to add c, sure I’ll get there . Got more out of this thread so far than over the last 12 months, so I’ll be watching this like a hawk. Very Happy
 Best ever LR110
Discovery II
RR Sport
IIDTool BT 
 
Post #136284023rd Oct 2014 1:53 am
View user's profile Send private message View poster's gallery Reply with quote
tobouk
 


Member Since: 01 Jun 2014
Location: Knutsford Cheshire
Posts: 35

England 

Update parts arrived, holding first project, using ready built board from fleabay, only cost £7, recompiled Alex's software for 16f648, tacked k line driver chip (£4) underneath, up and running, cheers Alex Thumbs Up Thumbs Up Thumbs Up Thumbs Up Thumbs Up



Next project, bottom right of photo shows pcb kit and LCD display, fleabay again, £17 all in. Hope to display commands between my telestart T90 and FBH, fault codes etc, this will be longer term project. Most interested in any "c" libraries already written for telestart comms, got some but could save some time if there's any shares going, still on a steep learning curve. Below picky new board already assembled. that's todays little job.


 Best ever LR110
Discovery II
RR Sport
IIDTool BT 
 
Post #136638130th Oct 2014 2:57 pm
View user's profile Send private message View poster's gallery Reply with quote
epninety
 


Member Since: 12 Oct 2012
Location: Hampshire
Posts: 329

Wales 2005 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

tobouk, you've got a PM Smile
  
Post #136696831st Oct 2014 6:29 pm
View user's profile Send private message View poster's gallery Reply with quote
tobouk
 


Member Since: 01 Jun 2014
Location: Knutsford Cheshire
Posts: 35

England 

Cheers epninety reply and thanks in PM Thumbs Up
 Best ever LR110
Discovery II
RR Sport
IIDTool BT 
 
Post #136709431st Oct 2014 11:00 pm
View user's profile Send private message View poster's gallery Reply with quote
tobouk
 


Member Since: 01 Jun 2014
Location: Knutsford Cheshire
Posts: 35

England 

Cheers epninety reply and thanks in PM Thumbs Up
 Best ever LR110
Discovery II
RR Sport
IIDTool BT 
 
Post #136709531st Oct 2014 11:01 pm
View user's profile Send private message View poster's gallery Reply with quote
M3DPO
 


Member Since: 22 Sep 2010
Location: Notts.
Posts: 8225

England 2014 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

As my 1533 timer has just died anyone who wants a guinny pig I'm available with a soldering iron Thumbs Up
 It can when others can't,
It will when others won't,
It goes where others don't. 
 
Post #13700857th Nov 2014 7:29 pm
View user's profile Send private message View poster's gallery Reply with quote
anglefire
 


Member Since: 09 Mar 2010
Location: In the Club House
Posts: 4180

England 

Finally got mine wired in (The basic original idea). My FBH itself was playing up and not working properly, so I got one from Duckworths (Almost as cheap as the repair kits) and fitted it yesterday.

I fitted it with a GSM "Gate" opener so can ring it up to start it. Programmed it in with a 2.5second closing pulse and works a treat.

Had it fired up this morning and even unlocked the car, replaced the pollen filter and locked the car again and it still just kept running Thumbs Up
 Mark.
2006, D3 SE Auto - gone but not forgotten.
2014 BMW 530d M Sport Tourer.
1977 Triumph Spitfire 1500

_________________________________________________
Disco Picture Website Here 
 
Post #137451616th Nov 2014 5:36 pm
View user's profile Send private message View poster's gallery Reply with quote
Jay666d
 


Member Since: 11 Feb 2014
Location: Northumberland
Posts: 753

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

Sounds promising... Thumbs Up
 07 Land Rover Discovery III HSE
07 BMW 1200 GS Adventure
08 Mercedes Sprinter 
 
Post #137456116th Nov 2014 7:05 pm
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru
 


Member Since: 19 Dec 2010
Location:  RO
Posts: 270


Small update.
Added temperature limit/target.
Details in the first post. http://www.disco3.co.uk/forum/topic106191.html
  
Post #137467816th Nov 2014 9:52 pm
View user's profile Send private message View poster's gallery Reply with quote
tobouk
 


Member Since: 01 Jun 2014
Location: Knutsford Cheshire
Posts: 35

England 

Thanks once again for sharing Alex Thumbs Up Thumbs Up
 Best ever LR110
Discovery II
RR Sport
IIDTool BT 
 
Post #137527318th Nov 2014 12:55 am
View user's profile Send private message View poster's gallery Reply with quote
VMatas
 


Member Since: 26 Jan 2012
Location: Rybnik
Posts: 152

Poland 

Alex, which version of Hitech C you used for compilation of source code?
  
Post #137531118th Nov 2014 8:19 am
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru
 


Member Since: 19 Dec 2010
Location:  RO
Posts: 270


HTPIC 9.50 inside an 8.84 MPLAB.
  
Post #137531218th Nov 2014 8:24 am
View user's profile Send private message View poster's gallery Reply with quote
Display posts from the last:  
Post Reply Back to top
Page 9 of 23 <123 ... 8910 ... 212223>
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site