Member Since: 28 May 2007
Location: Sydney, Australia
Posts: 128
Wheel weight & tyres
Just wanted to share my fun - new Cooper ATRs (LT265/70/17) on LR 17 inch wheels. I wondered about the change to unsrpung weight (unfortunately I could not weigh the new 17 combo vs the 18 inch standard setup). But, one interesting fact - wheel only, the LR 17x7 weighs 11.4kg. The 18x8 (5 spoke design 1) weighs 2.2kg more, so I've got a bit of scope to handle the heavier tyre.
So far, I am really pleased - clearly beefier, noise difference is imperceptible, and at 40psi, the ride has improved.
Last edited by Mr Andrew on 27th Jun 2007 9:33 am. Edited 2 times in total
25th Jun 2007 11:19 am
catweasel
Member Since: 05 May 2006
Location: Bundaleer
Posts: 4805
you could always click on the red triangle and report yourself or the mods will see your distress signal and wipe it, then again just don't worry about it. welcome Mr Andrew
25th Jun 2007 12:44 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73085
Or just put a smiley up there then everyone will wonder what you were up to!!
PS Welcome Mr Andrew!!!
25th Jun 2007 12:48 pm
catweasel
Member Since: 05 May 2006
Location: Bundaleer
Posts: 4805
there you go, tips from a problem poster an expert
25th Jun 2007 1:03 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73085
Hey CW, how did you know about my drink problem!!!
In particular, the last paragraph on page 2 says:
"The outside diameter of the wheel and tyre combination must be no more than 15mm over the largest diameter
wheel and tyre combination specified for the vehicle and not more than 15mm below the smallest diameter wheel
and tyre combination specified for the vehicle."
Looks like you have gone 39.6mm over the diameter of 17 and 18" tyres. Not sure what the diameter of 19" option.
Keep the above in mind when you go for your pink slip at the end of the year. You might like to find a garage which is sympathetic to 4x4s!
Cheers,
Rob
26th Jun 2007 3:52 am
Mr Andrew
Member Since: 28 May 2007
Location: Sydney, Australia
Posts: 128
Hi Rob
Yes, I did know about this, talked about it with the retailer, they said not an issue, and could be rectifed with an engineers cert. if I was worried about it. Quite frankly, I doubt if a normal person/inspector would even notice. And I guess if it gets desperate, I can bolt my std 18's back on.
Interestingly, the change in OD seems to have rectified my speedo error, speedo now matches gps much more consistantly.
What have you ended up doing? You have your AT2's on std 18s?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
or the mods will see your distress signal and wipe it, then again just don't worry about it. welcome Mr Andrew
smiley up there then everyone will wonder what you were up to!! 
