I am very well Stephan thanks. I have a CTEK msx7 as a power supply and a 2014 disc so all is well for once. It came back to life with a gearbox fault and engine fault but I turned it off for 2 mins and back on and it seems ok. I have not tried the sat nav on the move yet but I am sure it will be ok. I could not clear all faults or find any until I have re-installed the correct software on the IId tool. I have done that now and cleared all faults and reset car. I will give it a try when I go to pick my son up from work. The next thing I am going to tackle is replacing the rad water bottle as its giving a low coolant level warning. It seems straight forward in the explanation but still a tricky thing for me The worst problem I am having at the moment is when I stop at junctions or anywhere else for that matter and hold the car on the foot brake with the car in drive it feels like it is missing and when you set off it nearly stalls but when moving above 10mph it is fine. I have had this fault since before I had my gearbox and TC done so thought it would be fixed with that but no. The annoying thing is that it does not do it all the time. It seems worse when the the car is cold first thing.
31st Jan 2016 4:07 pm
tayaste
Member Since: 15 May 2013
Location: Chester
Posts: 7633
Result with the nav
Re: the stalling, is there any fault codes Mark?
This is before the update. Codes last read and cleared 2 or 3 weeks ago.
VIN: SALLAAA135A335232
Vehicle scanned on 30-01-2016 16:51
Using IIDTool BT V3.0 B2134
Auxilary Heater
B1D29-93 (2E) No start, even after restart attempt - Component failure - no operation
U1A44-6C (2E) Fuel level
Body Control
B1B01-87 (6C) Key transponder - Bus signal/message failure - missing a message
( at 236110 km )
B1B70-81 (28) Local interconnection network bus circuit 2 - Bus signal/message failure - invalid serial data received
( at 235600 km )
Engine TDV6
P0405-00 (2D) Exhaust gas recirculation sensor A - circuit low
P1936-00 (2D) Clutch switch/sensor signal
Traffic Message
B1A56-18 (2F) Antenna circuit - General electrical failure - circuit current below threshold
Vehicle Dynamic
U0100-87 (08) Lost communication with engine control module/ powertrain control module 'A' - Bus signal/message failure - missing a message
( at 235510 km )
31st Jan 2016 4:48 pm
RBP
Member Since: 29 Aug 2012
Location: N Yorks
Posts: 1936
Hi Mark, how's it going? Did you get any help at Icefest with the IID? Thought you'd return an expert?
Hi Richard I have done most things you can do with the tool. Disco Mikey,Geoff and Flack now come to me for help
If only Richard I have done cod, 3 flash indicators with help from Woody at Buxton (Thanks fella ) I have updated to MY7+ software and today done nav on the move so I am getting there. Hows things with you fella ?
31st Jan 2016 5:57 pm
RBP
Member Since: 29 Aug 2012
Location: N Yorks
Posts: 1936
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum