rsp
Member Since: 11 Jan 2006
Location: Goulburn, NSW
Posts: 161
  
|
All now fixed after some help from the IIDTool people.
Their advice was to use the guided calibration function and repeat it. I had tried it before and it seemed to stop lowering the first corner and I had assumed that was due to a red suspension fault occurring during the process.
The fault does not stop the process or, indeed, stop its initiation, as it came on at the start of the calibration, so I pushed through it even though the compressor was getting hot. IIDTool support said that the compressor would get hot and said that 105c was not a problem. In fact it went over 130c but once all corners were calibrated the red fault light went off.
I took it for a drive afterwards and it was cycling between about 110-132c, but on a subsequent trip after it had cooled down it was running around 32c with the height set at normal and with no changes made to that height.
So all seems ok. I have yet to check the other heights but assume they are ok. Disco 3 TDV6 HSE, Auto, White, Rear Diff Lock. ARB BB, Traxide DBS, GME TX3540S, Safari Snorkel, IIDTool-BT, Doran TPMS, Rijidij Spare Wheel Carrier, Two side by side Drifta drawers, cargo barrier and drop down fridge slide, ARB 47l Fridge, Yokohama A/Ts and out of date 17" Cooper STTs.
|
 9th Mar 2019 2:24 am |
|
|
