Member Since: 30 Jul 2019
Location: Moscow
Posts: 20
Chris Hagain wrote:
Just completed this modification today today, my D3 sat nav unit was toast, and the cost of updating was actually cheaper than replacing the D3 unit and got the benefit of newer maps. Also left a space under the seat, so fitted the UHF/VHF radio base unit under the seat
Thanks to Galvernised nuts for the guide and Pete K for advise
Simple and easy to do although a little daunting, but read the guide a few times prior, and things went smoothly, glad you mentioned about the Range Rover logo.
Does anyone have a code for the plug (reversing camera) and connector pins, so I can complete the installation
Member Since: 18 Aug 2019
Location: Banstead
Posts: 2
Greetings one and all!
It's been a long time since I posted on this site, but replacing the D3 SatNav with a D4 system is exactly what I need to do to my 57 Reg HSE. However, I don't have the ability to do it myself, so could someone please recommend a member / company who I could pay to do this? I am in Surrey.
Thanks in advance.
All the best.......BFP
28th Jul 2021 2:20 pm
Chris1573
Member Since: 12 Feb 2021
Location: Stroud
Posts: 196
Heads up for anyone after the plugs. The 6 pin reversing camera plug is a Molex 30700 range
Molex 30700-1060 Plug Receptacle. 6 pin
The Female Terminals are TE CONNECTIVITY / AMP 1393366-1
I think the Same range is for the 14 pin plug as well Molex 30700-1147
Farnell have the receptacles for a couple of £ but only sell the terminals by the 5000... but I have found the terminals on ebay for £4 for 10.
Just FYI...
12th Jan 2022 7:36 pm
Chris1573
Member Since: 12 Feb 2021
Location: Stroud
Posts: 196
Reversing Camera
Hi All,
Wiring up the reversing camera.
So got the 6 pin grey plug which I know you run the signal and ground wire to, however is one of the pins a +VE feed that I can link up to the camera or should I take this from the reversing lights ? My camera has come with a cable that has the option of running the +VE all the way along the cable to the front so I can have either option.
Thanks.
Chris.
29th Jan 2022 1:35 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10676
The 6 pin does not have power. All video input
Don’t connect to reverse lights. That won’t work best (the camera input stays active for 10 seconds while parking - if the camera has no power, screen will be blank)
One of the wires on the other plug can be used BLUE or the rear of cigar lighter
I recommend you run it thru a 1 or 2 amp fuse
or the blue wire an the antenna amps can be used.
Last edited by Pete K on 29th Jan 2022 1:54 pm. Edited 1 time in total
29th Jan 2022 1:46 pm
Chris1573
Member Since: 12 Feb 2021
Location: Stroud
Posts: 196
OK Pete, So the camera should be wired up to an ignition +VE so the camera will always be on when the car is running although won't display until reverse is selected....?
29th Jan 2022 1:52 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10676
Yeah.
Or the blues wires as in the edited post above
29th Jan 2022 1:55 pm
skunk38
Member Since: 05 Jan 2024
Location: South Wales
Posts: 115
I finally got around to fitting the RRS unit I picked up a few months ago thanks to Pete K seeing it on ebay.
As I like tinkering and things to be as 'plug and play' as possible, I got hold of some plugs/sockets that accommodate OE ones and made up a couple of connector looms, so I didn't have to mess around with removing pins from existing plugs or splicing wires etc..
I even got a MOST extension cable to save strain on the original D3 screen cable. It tucks away nice on top of the stereo and gives more room to play with during installation.
The info from others has been invaluable to do the mods, and modifications evolve as availability of parts gets better.
Click image to enlarge
Click image to enlarge
Volunteer driver with 4x4 Response South East Wales
Volunteer Rider for Blood Bikes Wales
Land Rovers owned -
Disco 1 - 300 Tdi - dead
Disco 1 - 200 series - 3.5 V8 on LPG - dead
Disco 2 - TD5 - sold
Disco 1 - 300 series - 3.9 V8 on LPG - sold
Disco 3 - TDV6 HSE - current
7th Aug 2024 10:52 am
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10676
Did you connector your tv then too?
What’s the other video I/p for?
7th Aug 2024 3:05 pm
skunk38
Member Since: 05 Jan 2024
Location: South Wales
Posts: 115
Yes Pete K, the Fakra is for the TV and the RCA connector is for the rear view camera.
I couldn't believe the difference in picture quality and I can get a good view of the towball as well as behind the Disco.
The only problem I've had, is not getting any voice directions on the satnav, but the GPS is working and follows me. I've checked the connection to the ABS wire and got good continuity from the DVD plug upto the D4 display unit. I know the maps are going to be out of date, and I use TomTom on my phone, I just like things to work if they're meant to. Volunteer driver with 4x4 Response South East Wales
Volunteer Rider for Blood Bikes Wales
Land Rovers owned -
Disco 1 - 300 Tdi - dead
Disco 1 - 200 series - 3.5 V8 on LPG - dead
Disco 2 - TD5 - sold
Disco 1 - 300 series - 3.9 V8 on LPG - sold
Disco 3 - TDV6 HSE - current
7th Aug 2024 9:29 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10676
The picture quality is better than what ?
Regarding nav. Try turning up the volume when it’s meant to be speaking.
May need to press repeat command first
You can go into the diagnostics screen and see the speed.
One from abs. One gps calculated.
7th Aug 2024 9:32 pm
skunk38
Member Since: 05 Jan 2024
Location: South Wales
Posts: 115
The picture from the camera and TV compared to the D3 screen is much better quality.
If I press the speaker button on the Nav screen after putting in a destination I get the voice message 'please refer to the map' at a good volume, so it has voice, but I will try what you suggested.
I had a check on the ABS sensors yesterday via GAP and all reading ok. The D3 nav worked fine too before.Volunteer driver with 4x4 Response South East Wales
Volunteer Rider for Blood Bikes Wales
Land Rovers owned -
Disco 1 - 300 Tdi - dead
Disco 1 - 200 series - 3.5 V8 on LPG - dead
Disco 2 - TD5 - sold
Disco 1 - 300 series - 3.9 V8 on LPG - sold
Disco 3 - TDV6 HSE - current
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
