What are you having problems getting to work? I have just done a 2015 wheel into a 2010. I have had to use my original packa for cruise control. Xhange thr plastic cover for the new one. Flappy paddles need a software update from gap to get them working via and iid tool. Heated wheel i have researched but basically needs a change of clock spring and then a constant power feed there is adaptor leads available in the shop on here.
Hope this helps.
8th Sep 2020 8:17 pm
Trailered Movements
Member Since: 16 Jan 2020
Location: East/West Sussex Coast Borders
Posts: 1200
Wow, that's thrown my research on this into doubt!
All searching on this site said the heated wheel option wouldn't work, and that was my main reason for the change, the flappys were a bonus.
I have the relevant clockspring, so all I need is a simple lead.
Where did you take power from?
Dave2011 Discovery 4 Commercial SDV6 (Gone)
2010 RRS TDV8 (Gone)
1980 OBLIC 4.0ltr Range Rover (went a long time ago)
The is the lead. 2 options either get your own piggy back to run of thr board. Or thr other cuts in into the cup lighter by drivers side.
My leads on order but have been assured this will work so happy to report back!!
8th Sep 2020 9:01 pm
Trailered Movements
Member Since: 16 Jan 2020
Location: East/West Sussex Coast Borders
Posts: 1200
I have the later heater module fitted in my wheel, and have had it confirmed by several that it will not work.
I am looking for an earlier module, but do not intend to fit this wheel as it is when there is little or no chance of it working.
Also been informed that the power lead is there in the cowling wrapped in grey foam.
Dave2011 Discovery 4 Commercial SDV6 (Gone)
2010 RRS TDV8 (Gone)
1980 OBLIC 4.0ltr Range Rover (went a long time ago)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum