I've seen many references that when connecting charger or jump-leads to a D4 (or most modern cars) you should connect to chassis or engine earth rather than battery negative.
But when I look under the bonnet, the only bare metal I can see is the FBH ... possibly not the best place to connect too if it's hot.
Looking just behind FBH, there are two earth points (only 1 used by look of it) but it would be awkward to clip jump-leads to either/both of them.
I'm thinking I'll get a thickish piece of copper and attach it on these two earth points ( look like 6mm bolts ) and have enough of it sticking upwards that jump-leads can clip on.
Is there anything wrong with this idea ? or is there a better place I've not spotted ?.
Dean
====================================
2011 D4 XS - OBD port protection, RLD spare wheel protector, All LED interiors lights, Timed Climate enabled, iiD tool paired.
2011 D4 Landmark - Stolen from same dealer before I paid for it
2011 D4 GS - Stolen whilst at dealer ... All LED interiors lights, DRLs, Spare Wheel protector.
1996 300Tdi - Eaten by tin worms
22nd Oct 2020 9:32 am
ianm27
Member Since: 02 Jun 2016
Location: Hertfordshire
Posts: 2154
Is this to stop the Flat Earth ?? Uncle Ray's spare wheel protector
Limo Tint
Blackvue front & rear dashcam
Cruise control switch pack
Bodsy's remote for FBH
22nd Oct 2020 11:47 am
J@mes
Member Since: 10 Nov 2008
Location: Bomber County
Posts: 4547
The manual appears to suggest connecting the negative to the suspension strut mount bolts.
I've been outside between showers and had another look.
solution is going to be something - possibly a stainless bolt flattened on one side - bolted to the FBH frame. Everything else I tried to fit to those bolts didn't help with the accessibility issue.
I'll post (pun ?) piccies when I get round to this … which will have to be soon as the youngster's Punto has needed jump starting a few times in the last couple of months.
22nd Oct 2020 3:32 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10684
just use the battery terminals !
22nd Oct 2020 4:59 pm
L319
Member Since: 14 Dec 2013
Location: Herefordshire
Posts: 2083
I haven't looked but if you take the cover off the engine I would think there a bare bolt or similar underneath
22nd Oct 2020 6:07 pm
Gary_P
Member Since: 03 May 2016
Location: Kent
Posts: 1668
Surely any bolt head screwed into the body will do. I use one right near the battery case. It's got paint on it, but I still get a good earth allowing me to charge.Gary
-------------------------------------------
Discovery 4 HSE 2016MY
22nd Oct 2020 7:00 pm
Gary_P
Member Since: 03 May 2016
Location: Kent
Posts: 1668
Any bolt going into the body work should do. I use one right near the battery case.Gary
-------------------------------------------
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
... All LED interiors lights, DRLs, Spare Wheel protector.
