Member Since: 19 Jun 2021
Location: NEWMARKET
Posts: 14
D4 tyre pressure monitoring
Can't find any useful info on here or the online manual so can anybody tell me what the parameters of the TPM on a 16 Landmark would be? I am regularly getting the little messages that it is set for up for light load but no pressure warning even though the NS rear was down to 27 today. Drove it after pumping it up to 37 but got no notification that it has changed.
Is there anywhere I can read about how it works and how low it needs to go before it tells me?
Thank you for your help, this is a recently acquired vehicle and I am still learning!
26th Aug 2021 1:04 pm
markate
Member Since: 17 Sep 2011
Location: England
Posts: 704
Tyre pressures are shown in the service menu on the screen between the speedo and rev counter.
To access the service menu turn the power on but don't start the engine and then cycle through the options until service menu appears and you can then access current tyre pressure, AdBlue levels and so on. You might have to drive a short distance to get the pressure to show.
Seem to recall it's supposed to warn if the pressure drops about 5psi below what it should be but it's not that accurate.
26th Aug 2021 1:10 pm
TobyB
Member Since: 19 Jun 2021
Location: NEWMARKET
Posts: 14
Thank you. I had forgotten that the engine needs to be not running. Is there a threshold low pressure that produces a warning on the dash? Or does one just have to check in the service section.
26th Aug 2021 1:41 pm
TobyB
Member Since: 19 Jun 2021
Location: NEWMARKET
Posts: 14
Sorry Markate, the 2nd para didn't appear on my phone.
So 10 psi down should have given me a fault message?
Reason I ask is that I am having al the 'new' car snagging sorted by the dealer and if the system is broken, I'll add it to the list.
26th Aug 2021 1:44 pm
markate
Member Since: 17 Sep 2011
Location: England
Posts: 704
Not sure to be honest, i know from experience it flags up when it's down to around 22 on most of the LR range.
Worth asking the Dealer to check but don't be surprised when they say it's working to design intent.
You might want to update your profile from D3 to D4!!
26th Aug 2021 2:01 pm
notyalc
Member Since: 07 Mar 2020
Location: Northumberland
Posts: 75
It tells you it’s set for light load because it is
If you had it set for max load it would tell you that instead.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum