Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Maintenance & Mods (D4)

EPB fault
Post Reply  Down to end
Page 1 of 1
Moleshome
 


Member Since: 15 Oct 2020
Location: Wokingham
Posts: 412

United Kingdom 2016 Discovery 4 3.0 SDV6 Landmark LE Auto Yulong WhiteDiscovery 4
EPB fault

Just got back home and when I applied the EPB it squealed at me and then gave me an EPB fault.

I just read the codes and initially got C1A46-64 (68) Actuator plausibility check ..., then when I pushed down on the button it tried and failed to release. Checked the codes again and it's now added U3000-4B (2B) Control module - system internal failure - over temperature.

I've tried pulling the wire loop and it comes up easily until it's about level with the top of the centre console and then won't go any further. I've no idea how farit should come up but it doesn't seem to be
having any effect. I've also tried going forwards and backwards but it won't release. Is it worth trying the unjam procedure in the Gap tool?

Any advice gratefully received.
  
Post #231827012th Dec 2022 10:22 am
View user's profile Send private message View poster's gallery Reply with quote
DIY Ace
 


Member Since: 06 Feb 2019
Location: Hampshire
Posts: 971

United Kingdom 2005 Discovery 3 TDV6 HSE Auto Bonatti GreyDiscovery 3

When this happened to me, I had to pull that wire so hard I thought it would snap. It didn't snap, and the EPB released.

Mine was caused by a disintegrated brake shoe in the off-side drum. Just collapsed into pieces when opened up. I rebuilt the drum on each side with all new bits, did the de-latch on GAP tool and then did the setting in procedure (see Bodsys Brake Bible on here) and it has worked perfectly since. That was a couple years ago.

Luckily I didn't need to touch the EPB module at all, it isn't a pleasant job from what I hear.
 2022 BMW i4 M50. Bought Oct 2022. 10,200 miles and counting...
2014 BMW 435d convertible. Bought July 2021. 58,000 miles and counting...
2005 Discovery 3 HSE Auto. Bought Feb 2019. 169,000 miles and counting...
2009 Freelander 2 XS Manual. Bought Sep 2013. SOLD Aug 2021 (already regretted!)

https://youtube.com/channel/UCO_u_0D45x9KGfiNstzLJnw 
 
Post #231828912th Dec 2022 11:27 am
View user's profile Send private message View poster's gallery Reply with quote
Landylad
 


Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366

Scotland 2012 Discovery 4 3.0 SDV6 GS Auto Zermatt SilverDiscovery 4

When you say delatch @Moleshome do mean to reset the of the module? I've replaced shoes and disc but when I had similar problem but when I applied handbrake, I just go similar intermittent screaching (not continuous like it did when it jammed) and brake hasn't engaged. I don't have GAP tool.
 If in doot, flat oot!!  
Post #235893114th Jan 2024 5:59 pm
View user's profile Send private message View poster's gallery Reply with quote
Landylad
 


Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366

Scotland 2012 Discovery 4 3.0 SDV6 GS Auto Zermatt SilverDiscovery 4

Getting these two fault codes:

U0128-00 (2F) Lost communication with parking brake control module

U0128-63 (2F) Lost communication with parking brake control module - Algorithm based failure - circuit/component protection time out

When I reinstated the new shoes into the rear assembly (after a bush fix to get them out!), the module made an initial screeching but didn't latch anything. Now it's silent. Nothing coming up on dash about brake fault.

Any clues? BTW, it's not jammed. I suspect I'll need to remove the module but I thought with the IIDTool, I could 'latch' but not seeing that option as part of the ECU fault.

Edit> Hang on.... I removed the bloody fuse to stop the brake binding on again. Let me refit and see what happens!!
 If in doot, flat oot!!  
Post #235925317th Jan 2024 2:43 pm
View user's profile Send private message View poster's gallery Reply with quote
Landylad
 


Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366

Scotland 2012 Discovery 4 3.0 SDV6 GS Auto Zermatt SilverDiscovery 4

Seem to be getting nowhere fast here. Nothing on the GAP tool seems to do the latch/unmount. Frustratingly, I engaged the parking brake and it's bound up again. Emergency release not freeing up that same side. So again faced with a jammed on brake. Surely not the shoes as they are brand new. Could the module, which keeps on winding itself, just get confused and go too far, pulling the cable to the point it binds on the brake shoes?
 If in doot, flat oot!!  
Post #235926817th Jan 2024 6:23 pm
View user's profile Send private message View poster's gallery Reply with quote
itsaguything
 


Member Since: 20 Dec 2023
Location: Manotick, On
Posts: 260

Canada 2015 LR4 3.0 SCV6 HSE Lux Auto Aintree GreenLR4

Incidentally, one of the symptoms of a failing battery is a malfunctioning EPB module…

I like to pick the lowest hanging fruit, first.
 2015 LR4 HSE Lux Aintree Green
2013 LR2 HSE Radiance Red
2007 XKR Jaguar Racing Green
2005 XJR Jaguar Racing Green
2002 S-Type R British Racing Green 
 
Post #235929918th Jan 2024 4:32 am
View user's profile Send private message View poster's gallery Reply with quote
Landylad
 


Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366

Scotland 2012 Discovery 4 3.0 SDV6 GS Auto Zermatt SilverDiscovery 4

Yeah, battery was low yesterday but the initial fault happened before that and only on the one side. I'm pretty confident the module needs unwound and reset.

Anyone tackled the module on a MY2012 D4 and figured if it's easier to get out from the side or from the rear (underneath)?
 If in doot, flat oot!!  
Post #235932018th Jan 2024 10:17 am
View user's profile Send private message View poster's gallery Reply with quote
Landylad
 


Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366

Scotland 2012 Discovery 4 3.0 SDV6 GS Auto Zermatt SilverDiscovery 4

Just bumping this - I'm seriously at a loss as to how to get the module out from my Disco. Access from rear is restricted by the subframe that houses the spare wheel winch cable. And there's very little chance of getting to the front of it to remove the torx bolts as the prop and other furniture is in the way. Even if I did miraculously get the panel off it, I'd not manage to my hands up to latch it or take the gears out.

Really would appreciate some advice from anyone who's mamaged this. Seems a lot easier on D3's or models that don't have the spare subframe in the way.
 If in doot, flat oot!!  
Post #235961921st Jan 2024 4:00 pm
View user's profile Send private message View poster's gallery Reply with quote
SJL160879
 


Member Since: 24 Jan 2024
Location: Barnsley
Posts: 2

United Kingdom 2011 Discovery 4 3.0 TDV6 HSE Auto Santorini BlackDiscovery 4
EPB Module not working

I have the dreaded screech , pulled emergency release cable, bought and fitted the repair kit for EBB
discovered that new shoes were required, these have bene fitted, now to re-attach the handbrake, my partner messed for 5 hours at the weekend in the end could get the handbrake to go on but wouldn't come off, does any one have any greatly appreciated tips please, at my wits end and sick of seeing the flashing warning lamp now Sad
  
Post #235987924th Jan 2024 12:20 pm
View user's profile Send private message View poster's gallery Reply with quote
itsaguything
 


Member Since: 20 Dec 2023
Location: Manotick, On
Posts: 260

Canada 2015 LR4 3.0 SCV6 HSE Lux Auto Aintree GreenLR4

1. As per the Workshop Manual, the first pinpoint test is confirm the condition of the battery.
(I am not convinced this was satisfactorily done)
It is premature to think there is a module issue at this very moment in time.
 2015 LR4 HSE Lux Aintree Green
2013 LR2 HSE Radiance Red
2007 XKR Jaguar Racing Green
2005 XJR Jaguar Racing Green
2002 S-Type R British Racing Green 
 
Post #23607382nd Feb 2024 8:03 pm
View user's profile Send private message View poster's gallery Reply with quote
SJL160879
 


Member Since: 24 Jan 2024
Location: Barnsley
Posts: 2

United Kingdom 2011 Discovery 4 3.0 TDV6 HSE Auto Santorini BlackDiscovery 4

Hi
Thanks for reply, battery has been changed recently

Any other suggestions greatly appreciated
  
Post #23607673rd Feb 2024 7:32 am
View user's profile Send private message View poster's gallery Reply with quote
itsaguything
 


Member Since: 20 Dec 2023
Location: Manotick, On
Posts: 260

Canada 2015 LR4 3.0 SCV6 HSE Lux Auto Aintree GreenLR4

“charged” means nothing.
Precisely, what is the resting voltage on the battery following 6 hours rest. If you are below 12.6 v, it needs replacement.
 2015 LR4 HSE Lux Aintree Green
2013 LR2 HSE Radiance Red
2007 XKR Jaguar Racing Green
2005 XJR Jaguar Racing Green
2002 S-Type R British Racing Green 
 
Post #23607743rd Feb 2024 11:11 am
View user's profile Send private message View poster's gallery Reply with quote
Admirable
 


Member Since: 19 Jul 2015
Location: Fife
Posts: 1039

Ukraine 2007 Discovery 3 TDV6 XS Auto Zermatt SilverDiscovery 3

Perhaps you guys may want some bedtime reading?

https://www.disco3.co.uk/forum/topic52130.html
  
Post #23607903rd Feb 2024 12:58 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site