I saw a post the other day with the exact positions to drill into the rear bumper for mounting the parking sensors, but I've searched and can't find it any more. Can someone measure the positions of their rear sensors please, so I can mount mine in the right place. I seem to remember they were all 1.5 inches down from the top, and a certain distance either side of the reflectors. Thanks Previously:
2005 D3 2.7 TDV6 S
1984 90 2.25 Petrol CSW
1992 90 200TDi Hard Top
1995 Discovery ES 300TDi
2003 90 TD5 Truck Cab
24th May 2008 8:12 am
DN D3 Decade
Member Since: 23 Jun 2006
Location: W.London.
Posts: 2344
ridgeback_moor, assuming your rear bumper hasn't got the raised 'bumps' where the sensors fit?, height wise the centres of mine (not retro fit),are all level with the centres of the reflector ie, 85mm down from top. Laterally the outb/d ones are both 43mm from outside edge of reflector to centre, and inner ones are both 152mm from inner edge of reflector to centre of sensor. (Sorry i've finally gone metric). HTH.
24th May 2008 10:14 am
GLYNNE
Member Since: 06 Oct 2006
Location: KENT
Posts: 4695
If you remove the rear bumper you will see where to drill through as it is marked out. When i fitted mine it was a fairly easy job to remove and then you can run the cables neatly and cable tie them.
Many thanks for the replies - I've drilled the holes in the positions in DND3's post and it's looking good - just have to wait for the raised bezels to dry (sprayed them black) before fitting. I'm fitting aftermarket sensors in genuine bezels so it looks original. Did it on the front too, with good results. Front and rear PDC for about 50 quid all in Previously:
2005 D3 2.7 TDV6 S
1984 90 2.25 Petrol CSW
1992 90 200TDi Hard Top
1995 Discovery ES 300TDi
2003 90 TD5 Truck Cab
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
