Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Maintenance & Mods (D3)

wheel arches
Post Reply  Down to end
Page 1 of 1
kog95
 


Member Since: 15 Nov 2009
Location: oxford
Posts: 31

United Kingdom 2016 Discovery 4 3.0 SDV6 Landmark LE Auto Santorini BlackDiscovery 4
wheel arches

I have bought new wheel arches for my discovery 3 and would like to change them my self.Is it a straight forward easy job and does anyone have any tips that might help me in the process Question
  
Post #5766378th Jan 2010 11:06 am
View user's profile Send private message View poster's gallery Reply with quote
DaveVX
 


Member Since: 15 Oct 2008
Location: Hampshire
Posts: 867

United Kingdom 2012 Discovery 4 3.0 SDV6 GS Auto Fuji WhiteDiscovery 4

found this earlier but not done mine yet..... far to cold.

Wheel arch removal guide (estimated time 1.5 hours)

If you have mud flaps remove them. (3 screws in each).


Rear quarter section removal x2
The rear quarter sections are held with 4 or 5 push in plastic clips inside the wheel arch itself. These are removed by prising out the centre and then removing the body of them. Easy, once you get one out for a look. Then a sharp tug on either end will start the clips at the top of the plastic arch coming away.
Rear door section x 2
The sections on the rear doors are held with 4 small torx headed screws through the rubber seal on the trailing edge of the door. Then a sharp tug will start the body side clips start to come away.

Front wheel arches x 2
Front arches are held with a screw inside the wheel arch liner area at the front corner. Then another 4/5 of the two part clips as per the rear quarters. The tricky fastener is in behind the headlights! Remove the grill (6clips, 4 along the top and 2 in between the slats lower down), remove the headlights (Disconnect the battery, if you are a worrier, 2 lift up bars on each light and disconnect the wiring.) Once in behind the headlight, there is a self tapper through the front wing into the arch. And finally, the front lower corner needs to be pushed straight up, and then pulled out from the bumper to release it from a "T" shaped retainer.
  
Post #5768348th Jan 2010 3:09 pm
View user's profile Send private message View poster's gallery Reply with quote
highbayrack
 


Member Since: 09 Jul 2008
Location: Northamptonshire
Posts: 2776

United Kingdom 2014 Discovery 4 3.0 SDV6 HSE Auto LuxorDiscovery 4

Make sure you get some extra plastic clips from your dealer before you start. They break easy, especially in this cold weather (I did mine in the summer and still broke quite a few) Thumbs Up
 On a mission to find the perfect Pork Pie. Just Found it (I think)..(Yes I have)
Official product sponsor for "Bloodhound SSC" 1000+ mph world land speed record 
 
Post #5769228th Jan 2010 5:03 pm
View user's profile Send private message View poster's gallery Reply with quote
kog95
 


Member Since: 15 Nov 2009
Location: oxford
Posts: 31

United Kingdom 2016 Discovery 4 3.0 SDV6 Landmark LE Auto Santorini BlackDiscovery 4

great info guys thanks very much Thumbs Up
  
Post #5776119th Jan 2010 1:36 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site