Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO4.COM as a guest - Register to take part or Log In
lomnex
Member Since: 28 Jun 2010
Location: Stavanger
Posts: 18
|
Hi,
I have a problem with my EPB not working, worked fine yesterday but trying to put it on today - no response.
No fault messages in display, and the fuse looks okay (the one next to the battery).
Anyone experienced this before? Or know if theres another fuse I can look at, or other things I can check.
Thanks
- André
|
28th Aug 2011 7:12 pm |
|
|
lomnex
Member Since: 28 Jun 2010
Location: Stavanger
Posts: 18
|
anyone? Must be something... no response at all when pulling the switch.. when turning key to ignition it shows the yellow (P) and a flash of the red (P). Both goes away - and no error messages in the display.
Is there a control module somewhere that I can check?
|
9th Sep 2011 6:03 am |
|
|
Bodsy
Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
|
Could just be a faulty switch. Or a Problem with the wiring. Bodsys Brake Bible
D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here
|
9th Sep 2011 6:26 am |
|
|
Matty 2332
Member Since: 02 Dec 2008
Location: West Yorkshire
Posts: 670
|
Usual cause is a break in the wire / coroded connection usually behind FNS wheel arch which can cause a loss of power or a reduction. if the voltage is below 10.4V or something similar, the module will not respond. I can forward you the instructions on how to check if you like. It could also be a faulty switch, simple 2 minute job to take it out and try another.
|
9th Sep 2011 6:41 am |
|
|
lomnex
Member Since: 28 Jun 2010
Location: Stavanger
Posts: 18
|
Thanks.
I stopped by the stealers in my frustration over this issue, and after resetting the brake module, clearing all other fault codes and so on... It finally throwed us a fault code for the brake switch!
Code was : Switch general electric failure
Anyone know where I can get a new one, and whats the cost of a new switch?
|
9th Sep 2011 7:45 am |
|
|
Bodsy
Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
|
Speak to Nick @ Yeovil LR. The cost of postage is likely to be more than the cost of parts,!
Or get Glen 'cold n wet' to pick one up before he flies back in your direction. Bodsys Brake Bible
D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here
|
9th Sep 2011 7:49 am |
|
|
|
Posting Rules
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO4.COM is independent and not affiliated to Land Rover.