noreserve
Member Since: 11 Dec 2006
Location: Atlanta, GA
Posts: 54
|
Land Rover/Warn winch mount |
|
Anyone out there with the Land Rover Genuine Parts LR3 Winch Assembly (VUB501470)? This is the one on expeditionexchange.com. I like it because it's subtle. Well, as subtle as a vehicle can be with a winch on the front end. The LR Experience vehicle I drove also had it, so it must work well. Just wanted to hear from some individuals before taking the plunge. I considered the ARB bull bar for the LR3, but it was just a bit much of a change to the front end which is nearly perfect as is. I have an HSE with the Park Distance Control, so I assume that I will lose at least the middle sensors.
|
18th Jan 2007 5:35 pm |
|
|
Slimer
Site Moderator
Member Since: 06 Jan 2005
Location: Last Exit to Nowhere
Posts: 16295
|
Go take that plunge! It does the job perfectly
I think (TFC?) you may be able to retain the middle sensors if you position them right The End
|
18th Jan 2007 6:00 pm |
|
|
AndrewS
Tarquin of the Desert
Member Since: 06 May 2005
Location: Y...... because I can
Posts: 10441
|
The middle sensors will be lost or moved. I could not be assed to relocate them as I figured I have a winch as a sensor. I left the middle sensors connected and simply cable tied them up out of the way, but you have to put some thick tape over the actual sensor. I used butyl sticky tape. In the Beginning there was nothing, which exploded.
|
18th Jan 2007 6:54 pm |
|
|