|
|
kenny
Member Since: 17 Jan 2010
Location: South West Aus
Posts: 79
  
|
Just put the stamp on the bottom of the box  It'll be fine 
I really do hope you can do the Oz delivery though 
|
 1st May 2012 12:44 pm |
|
|
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
|
My fridge arrived today only 24 hours after being paid for. Thanks to TLO for his speedy service and dudds for arranging the deal.
Fridge fitted this evening, along with replacement wiper blades. Think we know which will get more use this week.
|
| 1st May 2012 10:39 pm |
|
|
Renton
Member Since: 13 Jan 2009
Location: Somewhere in the middle
Posts: 1718
 
|
I assume the electrical connector is already in place below the cubby? CLUB ILLEGAL CAR WASHERS
|
| 2nd May 2012 10:26 am |
|
|
bigdave
Site Sponsor
Member Since: 04 Jul 2008
Location: Cornwall
Posts: 9872
|
It was on my 05 'S'
All things shipping, storage, transport. UK and worldwide.
E-mail info@md-couriers.co.uk
|
| 2nd May 2012 10:28 am |
|
|
bigdave
Site Sponsor
Member Since: 04 Jul 2008
Location: Cornwall
Posts: 9872
|
It was on my 05 'S'
All things shipping, storage, transport. UK and worldwide.
E-mail info@md-couriers.co.uk
|
| 2nd May 2012 10:28 am |
|
|
DSL
Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73134
|
And my 06 S. 
|
| 2nd May 2012 10:29 am |
|
|
Martin
Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18573
|
Ditto on my 06 SE 06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
|
| 2nd May 2012 10:29 am |
|
|
mrszymon
Member Since: 17 Apr 2012
Location: London
Posts: 425
|
Fridge arrived today, many thanks 
|
| 2nd May 2012 10:55 am |
|
|
mrszymon
Member Since: 17 Apr 2012
Location: London
Posts: 425
|
Ok, step two is "Remove the floor console upper panel." - does anyone have instructions for that?
-simon
|
| 2nd May 2012 11:25 am |
|
|
outofyorkshire
Member Since: 27 Apr 2009
Location: Emigrated to Notts
Posts: 1021
|
Remove screw & trim from under EPB & then pull off trim working your way round & easing up
You should then be able to disconnect HDC switches etc Cheers Ian
___________________________________________
MY13 FL2 HSE lux - just gone
MY10 D4 XS
MY07 D3 SE
Massey Ferguson 400 FIS AGTV - Arctic Cat by any other name...
Citroen C3 Picasso for SWMBO so we can remember what fuel economy is!!
Member of the Narpy torch club
|
| 2nd May 2012 11:31 am |
|
|
Renton
Member Since: 13 Jan 2009
Location: Somewhere in the middle
Posts: 1718
|
Ok, then I reckon I am covered with my 05 HSE. CLUB ILLEGAL CAR WASHERS
|
| 2nd May 2012 12:04 pm |
|
|
|
|
|
|
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
|
The alternative way is to do like I did last night:-
1. Wait until it starts to go dark. 
2. Find torch with almost flat battery.
3. Remove Ipod & lead if fitted.
4. Look for securing screws inside cubby box.
5. As no screws visible decide to try and pull box vertically on the basis of something must move (nothing did).
6. Look at fridge and find where retaining screws must be located.
7. Remove facia panel (the upright black panel to the rear of the cup holders) by carefully levering it upwards.
8. Using long nose pliers and a tork screw driver, remove the 2 screws which hold the cubby box in.
9. Remove the two larger tork screws and chrome covers from the sides of the cubby box lid and remove lid.
10. Lift cubby box out.
11. Locate cable and plug for fridge (ask self why is the cable that short!) 
12. Enter fridge in to hole with the fan end first.
13. Look for said cable and plug now lost under fridge. 
14. Take fridge out again and find suitable place to secure the plug ready for conecting.
15. Put fridge back in and spend 15 minutes with long nose pliers and fingers trying to get the plug in the fridge socket. 
16. Check fridge works.
17. Refit the two small torx screws and trim.
18. Wipe blood from back of hands, fingers, fridge, and trim.   
19. Carefully squeeze the rubber grommet with ipod cable back in to fridge moulding as missed doing it when fridge fitted.
20. Refit the cubby box lid.
21. Start car and test fridge still working. 
22. Go to bed wondering where to put the contents of the cubby box. 
|
| 2nd May 2012 2:21 pm |
|
|
Somerset Jem
Member Since: 07 Jul 2011
Location: Somerset
Posts: 435
|
Picking mine up from Nick at the weekend Get ready for the temperature to drop next week.
Great write up BB........I might need it!
Jem
|
| 2nd May 2012 2:29 pm |
|
|
