| Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO4.COM as a guest - Register to take part or Log In
Eaglehead
Member Since: 24 Mar 2012
Location: Zurich
Posts: 3
  
|
Hi all,
About a few weeks ago I noticed that there was some condensation within the nearside front fog lamp on my D4. I assumed it was transient and that the condensation would eventually go. Unfortunately it didn't and yesterday I noticed that the lamp lense had devloped some cracks.
Can anybody tell me the cost of replacing the lamp unit? By seaching on the Internet Ihave seen how the front fog lamp bezel comes off, but not how the lamp unit inside is replaced. Can anybody kindly direct me to instructions? Or am I better off going to the stealers to get the replacement done?
For the avoidance if doubt, I have searched this forum to no avail.
Many thanks in advance for the support.
Mr Eaglead
|
 29th Jul 2012 5:17 pm |
|
|
MrH
Member Since: 08 Aug 2007
Location: lost in the forest
Posts: 7754
|
No need for a stealers!
Remove the fog lamp, pull off the bezel and undo 3 screws, then unplug it. Then look for a small mushroom shaped plug which is the air vent, this is probably clogged with dirt, so pull it off and clean it under running water, then remove the lamp/bulb and dry out the foglamp unit in a warm oven. Let it cool before ressembling with little white grease on all the o-ring seals, that should sort it out and stop it recondensing.
Last edited by MrH on 29th Jul 2012 5:39 pm. Edited 2 times in total
|
| 29th Jul 2012 5:37 pm |
|
|
CUCO
Member Since: 26 May 2011
Location: Spain & Oleee!!!
Posts: 609
 
|
Ask in a ford dealer, try the ford focus one (if I remember well), much cheaper, same lamp. 
|
| 29th Jul 2012 5:37 pm |
|
|
Eaglehead
Member Since: 24 Mar 2012
Location: Zurich
Posts: 3
|
Thanks Mr H and CUCO.
Actually, sorry if I was unclear, its not just a question of condensation. The lamp lens is cracked in quite a f places. So I believe the lamp needs replacing. Does the guidance you have given still apply? I am supposing yes, just replace the lamp with a new one?
Another aspect that worri me is that if somethimg goesbwrong is there a chance I could invalidate the warranty?
Mr Eaglehead
|
| 29th Jul 2012 7:59 pm |
|
|
APL
Member Since: 14 Sep 2011
Location: Europe
Posts: 1130
 
|
If under warranty I'd see if your dealer will replace under warranty before doing anything else - if it has cracked under it's own accord then.......! 2016 Discovery 4 Commercial
2019 Discovery 5 HSE
|
| 29th Jul 2012 8:02 pm |
|
|
MrH
Member Since: 08 Aug 2007
Location: lost in the forest
Posts: 7754
|
Yes, replacement is a simple matter of undoing 3 screws , unplug the cable from the lamp at the back and the refit with a new unit.
|
| 29th Jul 2012 8:10 pm |
|
|
Eaglehead
Member Since: 24 Mar 2012
Location: Zurich
Posts: 3
|
Many thanks to everyone for their help.
Mr Eaglehead
|
| 29th Jul 2012 8:44 pm |
|
|
Russell
Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
|
There was one on e bay MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
|
| 29th Jul 2012 9:01 pm |
|
|
gashalot
Member Since: 30 May 2012
Location: Seattle
Posts: 8
  
|
One last note - when removing the screws, be sure to cover the small drain holes in the lower fixture. The first screw I removed fell straight in to the inner bumper structure!
|
| 1st Aug 2012 5:37 am |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO4.COM is independent and not affiliated to Land Rover.
