Member Since: 03 Nov 2007
Location: Glorious Devon
Posts: 3254
I don't think that you'll get the set cheaper than Slimer's deal.
They are a DIY job but there is a little difficulty in removal of the side vents. You need the strength of Garth and a palette knife basically.
The recommended technique (I kid you not ) is to stand with your back to the side vent, reach behind you, grab hold of the griill with both hands and using the strength of you legs and back pull upwards. This may (depending upon how strong you are) allow one or both of the lower tabs to release. Slip you padded palette knife in the gap and gently lever up and out. Put masking tape around the painted bearing surfaces before you use the knife. Putting the new ones is far easier.
The grill is a doddle. Release the tabs along the top by pressing down and pulling the grill outwards and then give as firm pull on the grill towards you and the two tags in the bottom of the grill will release. Make sure that the LR badge (supplied in the kit) is applied correctly.
Bill Wright Never take life too seriously. Nobody gets out alive anyway.
D4 SDV6 SE Tech Kaikoura Stone MY15.
Last edited by Bill Wright on 8th Mar 2013 4:19 pm. Edited 1 time in total
8th Mar 2013 1:08 pm
petersw
Member Since: 17 Nov 2012
Location: Norfolk
Posts: 1135
Is this a thing I could do twice a year, i.e. swap between them summer and winter or would it break the parts ?
May have to look into some of these, think they would look good on the G4.......G4OC Secretary
N44RT Callsign NH89
8th Mar 2013 1:37 pm
DaveT
Member Since: 01 Aug 2005
Location: Cornwall
Posts: 2575
Can vouch for the authenticity & quality of Slimers grilles
... and confirm the difficulty of removing the side air intake grilles Long succession of Disco's since 2001...
SIII Lightweight - neglected & rusting. Bulkhead, A panels, vent panel & outriggers now disintegrated - Next years project!
8th Mar 2013 9:50 pm
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15261
DurtyDisco wrote:
May have to look into some of these, think they would look good on the G4.......
..... but maybe a little difficult to fit ...... cos its for a D4....... always on the road less travelled 🚧
8th Mar 2013 10:54 pm
powervideo
Member Since: 20 Feb 2013
Location: Victoria
Posts: 10
I just managed to put genuine LR Santorini vents in my D4. Man I thought the right side one was never going to come out. It was damned hard. Looks good but I'm not sure if it's too much black!
24th Jun 2013 6:03 am
euangibson
Member Since: 24 Dec 2010
Location: Borders
Posts: 11027
Yes,I can confirm they are a pig to do.....but worth it when they're done 8) ...I found that if you get a really long screwdriver,you can reach down behind the body panel where the bonnet hinge is sited....you can them pop the clips and it makes it (slightly) easier...
+1 for the set supplied by Slimer "Better to remain silent and be thought a fool,than to speak out and remove all doubt" ?.....what rubbish...
Locking rear E-diff
RLD spare wheel protector & sump guard
Extended roof rails
Series 111 mudflaps
Black side tubes,grill and vents
Timed climate remote
Hids4u interior lights
D4 Firenze my2012 HSE
D3 Java 2005 SE manual (sold,sadly,thanks for the memories)
1966 '88 Series 2a....still starts in the morning better than I do...
24th Jun 2013 6:10 am
dangerdave
Member Since: 23 Nov 2010
Location: <>
Posts: 4495
Admin note: post content removed at user request
24th Jun 2013 6:20 am
Russell
Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
Long screw driver through hole by bonnet hinge, pop two top clips and vents come out very easily. MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
24th Jun 2013 6:36 am
powervideo
Member Since: 20 Feb 2013
Location: Victoria
Posts: 10
No fear, no fear, no fear..... PULL!
24th Jun 2013 9:45 am
MarkOne
Member Since: 23 Jul 2011
Location: County Antrim
Posts: 3345
Good advice from Russell as you will be break at least 1 clip pulling it off.
24th Jun 2013 10:27 am
Russell
Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
They are really easy to get off if you follow my advise, shine a small torch down the holes and you will see the clips.MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
24th Jun 2013 1:33 pm
petersw
Member Since: 17 Nov 2012
Location: Norfolk
Posts: 1135
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum