Member Since: 22 Sep 2010
Location: Notts.
Posts: 8230
[Wanted] Cam locking pins
Anyone got a set they want to part with?It can when others can't,
It will when others won't,
It goes where others don't.
14th Jan 2021 10:16 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5045
6mm drill bits will do the job well if you're stuck!!yµ (idµ - eAµ) ψ=mψ
15th Jan 2021 12:49 am
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8230
I do have some cheap ones but they measure 5.7mm, all others seam to be 5.9mm, as it’s the first time I have changed the belts on a D4 I don’t want to take any chances, would 0.2mm undersized cause any problems?It can when others can't,
It will when others won't,
It goes where others don't.
@M3DPO You do know the rear belt is timed on the D4?.. You will be fine with your drill's for the front belt.
Flack
15th Jan 2021 9:55 am
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5045
Yes 5.7 will be fine as you are only looking to hold the sprockets in place!yµ (idµ - eAµ) ψ=mψ
15th Jan 2021 10:34 am
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8230
Flack wrote:
@M3DPO You do know the rear belt is timed on the D4?.. You will be fine with your drill's for the front belt.
Flack
Yes I do know thanks, out of curiosity what are the consequences if one was put on out of correct timing?It can when others can't,
It will when others won't,
It goes where others don't.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
