Rear Door Latch Replacement
From DISCO4.COM Knowledge Base
Introduction
Following up and extending Iain G's excellent thread regarding changing the front door latch, here is a guide for doing the same for the rear doors.
I carried out this work on the rear left hand door (passenger's side in UK).
As of October 2011 the part numbers for the rear door latches for a UK specification car are :
- Rear Left - LR011303
- Rear Right - LR011304
Both retail at £61.50 + VAT before any discount (October 2011).
Mine came from Yeovil Land Rover with a 20% DISCO3 discount :)
This should be read in conjunction with Iain's guide linked to above
Tools Required
- 10mm socket and ratchet
- T30 Torx bit and ratchet or Torx tool
- Medium sized cross point screwdriver
- Penknife and/or small and medium flat blade screwdrivers are very helpful for releasing clips
- Parcel or duct tape
- Something to prevent tape sticking to bodywork, like a sheet of newspaper or plastic carrier bag
Accessing the latch
Door card removal
See also the official Land Rover service procedure for rear door card removal.
Door card removal is similar to for the front door.
- Wind the window down to about 1/3 open (i.e. gap of about 6"/15cm above glass)
- Unclip and remove the top part of the internal door grab handle by freeing the clips underneath it with a medium sized flat blade screwdriver. The plastic is soft and cracks/tears easily so take care.
- Using the penknife blade lever out the round plastic cover behind the door lock handle, it is captive to the door card by a plastic strip so won't drop out.
- Remove the 7 screws from the door card
- 1 from behind the door lock handle
- 4 from the grab handle
- 2 from the bottom of the door (loooong screws!)
- The door card is now loose and can be pulled gently from the door. I could release mine at the bottom quite easily, and the remaining clips (plastic sides/bottom, metal at the top) released easily without breaking. Be careful removing the door card as there is wiring and a lock cable attached to the door card.
- Remove the electrical plugs - I had the three below but there may be more or fewer depending on your spec (e.g. no puddle lights or rear headphone controls)
- 1 for electric window switch
- 1 for speaker
- 1 for puddle light
- Remove the door lock handle cable. There are two ways of doing this