- You are currently viewing DISCO4.COM as a guest - Register to take part or Log In
|
|
|
|
reggs
Member Since: 23 Dec 2010
Location: Warrington
Posts: 23
  
|
Ditto.
Mine nearly froze the Mrs's fingers off. Didn't think it would be that good, but it is.
To confirm....on the D4 MY2011 the fridge powers immediately off when you lock the doors.
Top Notch.
Thanks guys 
|
 2nd Aug 2014 5:27 pm |
|
|
moles
Member Since: 27 Oct 2008
Location: Tunbridge Wells
Posts: 48
|
Hi, Please could someone help with the following questions before I exert too much pressure and cause real damage !
I have removed cup holders and black plastic plate below them. Do I need to remove the parking brake switch ? If yes, is there a screw under the black central cap on the switch ?
I see there is an electric plug without a connector to it under the black plate - is this where the connector from the fridge goes ?
I have read that there are two torque bolts to remove from behind the vertical black plastic that will be accessible once the central unit is removed - are these the same size as the bolts in the hinge lid ?
Any other tips would be welcome !
Thanks moles
|
| 3rd Aug 2014 9:14 am |
|
|
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
|
Hi moles, ok you are almost there.
Looking at your profile I can see that you have a 2012 car so assuming rotary gear selector.
If you have the cup holders out, there is a drip tray under that has 2 screws. Remove these
Next, grip under the full central console near to the cubby on both sides and pull upwards fairly hard, but with controlled pressure.
The whole central console area will now unclip and lift off. It will still be attached to the loom.
Next, unscrew the two screws that were behind the black plate that we discussed above.
Unscrew the hinge screws for the lid, and unclip the covers by lifting them upwards.
Remove the gromit thing that takes the USB cable through to the lid.
Pop out the old cubby.
Replace with the fridge unit but make sure all your cables route through the necessary feeds. You will need to clip in the connector at this point which goes under the side of the fridge and clips into the units own connector. This is covered with foam for identification.
Put it all back together again... Tada!
Justin
Discovery 4 MY14 XXV Causeway Grey
RRS MY12 Autobiography
Discovery 4 MY12 GS
Nanocom, Cruise Control, Cubby Fridge, TomTom SatNav, Xenons, BlackVue
|
| 3rd Aug 2014 9:20 am |
|
|
moles
Member Since: 27 Oct 2008
Location: Tunbridge Wells
Posts: 48
|
Thanks for the quick reply, will go out for another try but might need to borrow the correct size torque bolt to continue as only have limited tools. moles
|
| 3rd Aug 2014 9:33 am |
|
|
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
|
Yes, you will need 2 torx bits... one small and one large. Best bet is to go out and buy a cheap socket set from Halfords, or Asda have them for £10 Justin
Discovery 4 MY14 XXV Causeway Grey
RRS MY12 Autobiography
Discovery 4 MY12 GS
Nanocom, Cruise Control, Cubby Fridge, TomTom SatNav, Xenons, BlackVue
|
| 3rd Aug 2014 9:36 am |
|
|
reggs
Member Since: 23 Dec 2010
Location: Warrington
Posts: 23
|
The two torx bolts holding the old cubby in place are T20. They are at the front of the cubby and are exposed once you lift the central console which should be gently placed on the passenger seat as cables are still attached.
The hinge lid bolts are T40 but I don't believe that you need to remove the hinge lid to get the old cubby out and the fridge back in. The wire and grommet going up to the iPod connector are a little awkward to slip out, so removing the lid may help, but I don't think that its 100% required.
|
| 3rd Aug 2014 9:58 am |
|
|
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
|
You are right reggs, its not necessary to remove the lid but it makes getting that grommet out 1000 times easier so I would definitely recommend it if you have the right Torx bit. Justin
Discovery 4 MY14 XXV Causeway Grey
RRS MY12 Autobiography
Discovery 4 MY12 GS
Nanocom, Cruise Control, Cubby Fridge, TomTom SatNav, Xenons, BlackVue
Last edited by Parallax33 on 3rd Aug 2014 10:11 am. Edited 1 time in total
|
| 3rd Aug 2014 10:09 am |
|
|
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
|
how long did it take to cool down reggs? Ive been on a couple of 30 minute journeys and its not even cool by the end of them. Driving to Leicester on Monday so that will be a good test Justin
Discovery 4 MY14 XXV Causeway Grey
RRS MY12 Autobiography
Discovery 4 MY12 GS
Nanocom, Cruise Control, Cubby Fridge, TomTom SatNav, Xenons, BlackVue
|
| 3rd Aug 2014 10:10 am |
|
|
moles
Member Since: 27 Oct 2008
Location: Tunbridge Wells
Posts: 48
|
Thanks to Parallax 33 for organising the purchase of, and helping me through fitting, the cubby fridge. With Geoff fitting the remote control for the fuel-burning heater I now have the two extras that I could not order from new as the car was already in build. The dealer told me the remote fbh "could not be retrofitted to my car" so I didn't even bother to ask them about the cubby fridge.
While refitting the centre console it also enabled me to tidy away the wires for the Roadhawk camera.
Interesting to see that you hope to retrofit leather interior. I would be interested in some orange panels, or even complete orange seats with black stitching if that is possible. moles
|
| 3rd Aug 2014 1:55 pm |
|
|
reggs
Member Since: 23 Dec 2010
Location: Warrington
Posts: 23
|
Parallax33 wrote:how long did it take to cool down reggs? Ive been on a couple of 30 minute journeys and its not even cool by the end of them. Driving to Leicester on Monday so that will be a good test
Mine is really cold in about 10 minutes. I am really surprised 
In the past I've had one of those 1 x Budweiser beer can cooler things in the office.
It had a small standard PC fan glued to the side and it was rubbish.
We just used it for cooling a small plastic milk bottle next to the coffee machine, but it always struggled in an office full of high end PC gear chucking out loads of heat and eventually the fan gave out. I swapped the fan for a better one, but it wasn't particularity cool especially on hot days.
These fridges however are the real deal. Properly insulated. Nice big fan and vents.
All good.
Is your fan clear of all obstructions at the front ?
|
| 3rd Aug 2014 2:31 pm |
|
|
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
|
Hey! That's great, glad you got sorted in the end
Watch this space for leather. I am trying to work out a good deal  Justin
Discovery 4 MY14 XXV Causeway Grey
RRS MY12 Autobiography
Discovery 4 MY12 GS
Nanocom, Cruise Control, Cubby Fridge, TomTom SatNav, Xenons, BlackVue
|
| 3rd Aug 2014 2:36 pm |
|
|
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
|
Reggs, I just went for a 10 min drive and when I came back te fridge was really cold. Maybe it was initial bedding in or something. Will see how it goes tomorrow.. Justin
Discovery 4 MY14 XXV Causeway Grey
RRS MY12 Autobiography
Discovery 4 MY12 GS
Nanocom, Cruise Control, Cubby Fridge, TomTom SatNav, Xenons, BlackVue
|
| 3rd Aug 2014 2:38 pm |
|
|
Cpt
Member Since: 08 Jan 2020
Location: Australia
Posts: 7
|
Hi all,
I'm a new D4 owner. I know I'm a "little" late for this group buy but is there any chance it would still be possible to get one of these cubby box fridges?
Many thanks
|
| 19th Jan 2020 9:34 am |
|
|
Sea Raider
Member Since: 01 Nov 2016
Location: None
Posts: 4450
|
Might be worth contacting Duckworths for a price
If you do decide to buy one, order the tray for the inside as well as it doesn't come with the fridge
https://www.disco3.co.uk/forum/member-duckworthparts.html
|
| 19th Jan 2020 9:38 am |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
