duc1098
Member Since: 29 May 2012
Location: Kongsberg
Posts: 22
  
|
The Large One wrote:MartinR wrote:Topix has a bulletin that sounds related: LTB00479v2 3.0L TDV6 Exhaust Weld
Don't suppose anyone knows what it says?
SECTION: 309-00
3.0L TDV6 Exhaust Weld
AFFECTED VEHICLE RANGE:
Discovery 4 / LR4 (LA)
Model Year: 2010-2012
VIN: AA510178-CA638508
Range Rover Sport (LS)
Model Year: 2010-2012
VIN: AA212145-CA771688
MARKETS:
All Diesel Markets
CONDITION SUMMARY:
Situation:
This bulletin is for information only.
This version has been issued for a change to the Summary.
NOTE: The one piece exhaust is production fit only. For service repairs where the weld has broken prior to the cut off VIN numbers please refer to TOPIx Workshop Manual, section 309-00 Exhaust System for repair guidance.
A new (weld less) one piece exhaust system has now been introduced from Production from the following VIN numbers – Discovery 4 – CA638508 Range Rover Sport – CA771688
If appropriate a local repair of the weld can be claimed under a ZZZ001 warranty claim.
Cause: Poor weld during manufacturing of the exhaust at the supplier.
Hi.
My D4 is whitin the vin number mentioned in this post(AA53....) but not whitin CA63... The dealer has allready welded the rigth hand pipe, 15-20 inches before the rear muffler. I assume that the left side also will break, but my warranty expires in mars month. Should i accept welding as proper fix, or should i insist on replacement of the rear exhaust system?
Jan G [/quote]
|
 3rd Feb 2013 10:12 am |
|
|
MartinR
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
 
|
Not sure what you mean by in the range/not in the range? My dealer just replace the centre section then clamped the tail pipes back on, both sides, no arguing. given there is a tsb on it, I'd be tempted to go back to the dealer before the warranty is up and ask what they're going to do about it
|
| 4th Feb 2013 10:46 pm |
|
|
