Member Since: 17 Jun 2008
Location: widnes, cheshire
Posts: 117
P0715-00 (2F) Turbine/Input shaft speed sensor A circuit
Hi guys,
After a bit of advice please
Replaced the clutch and flywheel on the disco 3 yesterday, regraded the codes with the IID tool but I’m not getting the following fault. Any idea what’s causing it? Anyone tell me where the sensor is or where the loom is don I can check it’s not being damaged when we fitted the clutch. Car won’t go into low range now but everything rose seems ok
Any advice appreciated
21st Dec 2020 7:11 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4985
It's most likely one of the plugs on the transmission is not quite locating correctly, or there is damage at the plug. The XYZ sensor will be fine, it's the others you need to check carefully! yµ (idµ - eAµ) ψ=mψ
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum