Member Since: 21 Oct 2016
Location: kent
Posts: 13657
Sea Raider wrote:
gstuart wrote:
aja4x4 wrote:
gstuart wrote:
Pete K wrote:
IF the speaker doesn't work, then the system is pointless.
It should at least give an error tone or distance tone at some point if its working
Got to sort mine out and does just that, amber light flashes on the dashboard and the speaker gives a constant tone for a few seconds
Done some checking and it’s the loom so got to take the bumper off
Its ten minutes work to get the bumper off and a good time to clean away all the crud behind it
I’ve heard about those 10 x min jobs
Bless u as I did have a brief look at the instructions removing the bumper and seemed a lot longer , also found someone in the past has used half a ton of silicone to hold some of the loom connectors onto the sensors , so don’t know if it may be worth replacing the sensors at the same time
I removed the rear bumper from the Scrapper last week and have to say was a lot easier that I though it was going to be, you need to remove or at least get in behind the rear inner wheelarches and arch trim to release a popper each side but thats probably the hardest bit, then a couple of bolts and screws, 10 is a bit optimistic I'd say, best to set aside 11 to be safe
Lol, cheers mate , it was those side ones I was thinking about and how hard it would be to get them out
Are the visible or do u have to take the wheel arch liner out please or are they tucked up behind the exhaust heat shields , many thks
29th Jan 2020 1:09 pm
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13657
stew 46 wrote:
I’m not fixing mine because Julia won’t drive it without them
Brilliant
29th Jan 2020 1:09 pm
markagj
Member Since: 03 Dec 2015
Location: Wrexham
Posts: 175
gstuart wrote:
markagj wrote:
“Done some checking and it’s the loom.”
What checks did you do to come to the conclusion that the loom is the cause of your problem, please?
Hiya
Used a multimeter to test continuity from the connectors to each end, found a break in 2 x wires but will have to remove the bumper to find the breaks, but bought a new loom as it’s in a mess with silicone all over the connectors
Hi,
Thanks for that, it gives me a starting point.Discovery 4 HSE SDV6
Land Rover series 3 2.5 Petrol
29th Jan 2020 8:49 pm
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13657
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum