Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D3)

disco3 won't crank or start
Post Reply  Down to end
Page 10 of 10 <12345678910
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 13657

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

Also some forum pics showing where some of the looms go, canbus wires easily identified where 2 x wires are twisted with one another

Also put this here so it follows ur thread , indeed as mentioned would investigate that rear connectors seeing it resolved tbe issue before , otherwise ur drive urself nuts going from one place to another

https://www.disco3.co.uk/forum/post2338837.html#2338837

Indeed would also check the interior body sills to ensure there’s no water ingress where the looms are

Hope it helps


Click image to enlarge


Click image to enlarge


Click image to enlarge


Click image to enlarge


   
Post #233907911th Jun 2023 11:56 am
View user's profile Send private message View poster's gallery Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 13657

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

Also forgot to add, if the disco won’t start and has dropped to low to get a jack underneath u can remove the suspension relay and bypass it with a short piece of wire in order to raise the vehicle just enough to get a jack under it

https://media.disco3.co.uk/gallery/albums/...iption.pdf

Also wonder if the gap iid can activate the air compressor

Would anyone else be able to confirm what relay link terminals are required plse , many thks as always


Click image to enlarge



Click image to enlarge
  

Last edited by gstuart on 11th Jun 2023 2:40 pm. Edited 1 time in total 
Post #233909211th Jun 2023 1:58 pm
View user's profile Send private message View poster's gallery Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 13657

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

Just remembered ref the key buttons to raise it , fingers crossed it works

Sorry I’m waffling again , lol


To set the remote to raise or lower the air suspension, turn off the engine and remove the key.

Within one minute, press and hold the Land Rover button on the key fob whilst pressing the air suspension control lever on the Terrain Response area of the centre console (to either position, up or down).

The suspension can then be adjusted using the remote key fob.

The hazard warning lights must first be turned on and all doors closed. To raise the suspension, hold down the Land Rover button whilst pressing and holding the lock button.

To lower the suspension, hold down the Land Rover button whilst pressing and holding the unlock button.
   
Post #233909411th Jun 2023 2:29 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 10 of 10 <12345678910
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site