Wiggy Man
Member Since: 14 Nov 2010
Location: Hampshire
Posts: 158
  
|
I believe a oil change in a 2.7 tdv6 is 5.45litres so you should be adding 275ml to the oil. Looking forward to hearing some results, especially MPG. I like others on here change oil at more frequent intervals, I'm every 7.5k at aprox 3 months. So would get expensive.
Good luck 
|
 1st Jun 2012 11:12 am |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
 
|
Deleted
Last edited by Hess on 3rd Jan 2013 11:47 pm. Edited 1 time in total
|
| 1st Jun 2012 1:38 pm |
|
|
Renton
Member Since: 13 Jan 2009
Location: Somewhere in the middle
Posts: 1718
|
Been using it since last Thursday and it defenitely seems that the engine runs smoother.
- On ignition the engine sounds less rough.
- More quiet at cruising speed
But the biggest improvement is this (don't know if any of you expereience the same);
When I am driving and I take my foot of the throttle there is a distinct resonance/vibration/noise when the speed drops. Its not loud or disturbing, more a bit annoying. When my car is serviced and the oil has been renewed these symptons have gone to reappear again over a few thousand Km.
This resonance/noise now has become a lot less to a stage where it's no longer annoying.
Lubrication seems to be much better because of TSL and therefore probably less wear on the engine.....
Can't comment on the MPG at the moment as I only have done short distances and no highway. Will comment on that as well as soon as I have done a long stretch.
I used it for my Freelander as well but don't have feedback on that yet. Poored the remainder into the Disco's fueltank this afternoon.
So far I can recommend it everybody. CLUB ILLEGAL CAR WASHERS
|
| 4th Jun 2012 5:25 pm |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
Thank you kindly for the review, Renton.
|
| 4th Jun 2012 7:52 pm |
|
|
Renton
Member Since: 13 Jan 2009
Location: Somewhere in the middle
Posts: 1718
|
I also had a 2-3 second rattle on a cold start. Talked about it with the stealer but they didn't see it as an issue. Read more members here had this rattle.
Since I poored TSL in oil the rattle has gone.... CLUB ILLEGAL CAR WASHERS
|
| 7th Jun 2012 8:38 am |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
Deleted
Last edited by Hess on 3rd Jan 2013 11:48 pm. Edited 1 time in total
|
| 14th Jun 2012 4:11 pm |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
Deleted
Last edited by Hess on 3rd Jan 2013 11:48 pm. Edited 1 time in total
|
| 14th Jun 2012 4:57 pm |
|
|
lmorris4975
Member Since: 18 Oct 2011
Location: Notts
Posts: 48
 
|
Hi would TSL be ok with the D4 3.0 ltr engine ? What sort of Guarantee (if any) come with it about not damaging the engine ( i have heard horror stories about engine additives causing all sorts of problems) What size would i need to buy for the 3ltr diesel engine ?
|
| 15th Jun 2012 10:46 am |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
Deleted
Last edited by Hess on 3rd Jan 2013 11:48 pm. Edited 2 times in total
|
| 15th Jun 2012 3:55 pm |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
Deleted
Last edited by Hess on 3rd Jan 2013 11:49 pm. Edited 1 time in total
|
| 15th Jun 2012 3:57 pm |
|
|
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20841
|
Hess wrote:I've just uploaded a demonstration of TSL Oil Fortifier using the Timken Lubrication Test Machine.
It has English subtitles and demonstrates the machine being tested under load with
normal engine oil, then with TSL added and afterwards with no engine oil at all, only TSL.
Please check it out here: http://www.youtube.com/watch?v=2I_ngIKOEEU
Thank you in advance for watching it
Activ8:
ZX1 Xtralube: &feature=related
All the same IMHO. Still not convinced either... My D3 Build Thread
TDV8 Retrofit Build Thread
|
| 15th Jun 2012 6:01 pm |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
All good and well putting a torque wrench on it and a bloke pushing it down
but in the TSL video there is 300KG hanging on it.
That'd be a bloke weighing 660 pounds hanging from the Torque Wrench.
|
| 15th Jun 2012 7:08 pm |
|
|
Hess
Member Since: 07 Mar 2011
Location: Highlands
Posts: 1533
|
Deleted
Last edited by Hess on 3rd Jan 2013 11:49 pm. Edited 1 time in total
|
| 17th Jun 2012 10:01 pm |
|
|
Popelka
Member Since: 31 May 2008
Location: Praha (Prague)
Posts: 2430
|
| if it saves $73+ per bottle |
|
then it maybe worth at least to keep getting the savings but what are the really LONG long term benifits to the engine at a mechanical level
it might be worth watching this regarding those test 
&feature=related
best get head & shoulders  Experience is a difficult teacher, because she gives the test first and then the lesson afterwards!!!!
|
| 21st Jun 2012 8:04 am |
|
|
|
|
